LG Electronics RH188H, RH199H owner manual Language Settings, Audio Settings, Initialization

General Settings (Continued)

Initialization

You can reset the recorder to its original factory settings and initialize the HDD.

[Factory Set] If you need to, you can reset the recorder to all its factory settings. Some options cannot be reset. (Rating, Password, and Area Code)

[HDD format] Initializes the HDD (Hard Disk Drive): everything recorded on the HDD will be erased.

1.Select [Initialize] option then press B.

2.Press v / V to select the desired option then press

ENTER.

The confirm message will appear.

3.Use b / B to select [Yes] or [No] then press

ENTER.

Language Settings

Display Menu

Select a language for the Setup menu and on-screen display.

Disc Menu/Audio/Subtitle

[Original]Refers to the original language in which the disc was recorded.

[Other] To select another language, press number buttons then ENTER to enter the corresponding

4-digit number according to the language code list in the reference chapter (see page 55). If you enter the wrong language code, press CLEAR.

[Off](for Disc Subtitle) : Turn off Subtitle.

Audio Settings

Each DVD disc has a variety of audio output options. Set the recorder’s Audio Output according to the type of audio system you use.

Dolby Digital / DTS / MPEG

[Bitstream]: Select “Bitstream” if you connect the recorder’s DIGITAL AUDIO OUT jack to an amplifier or other equipment with a Dolby Digital, DTS or MPEG decoder.

[PCM] (for Dolby Digital / MPEG): Select when connected to a two-channel digital stereo amplifier. DVDs encoded in Dolby Digital or MPEG will be automatically downmixed to two-channel PCM audio.

[Off] (for DTS): If you select “Off”, the DTS signal is not output through the DIGITAL AUDIO OUT jack.

Sampling Frequency

If your receiver or amplifier is NOT capable of handling 96 kHz signals, select [48 kHz]. When this choice is made, this unit will automatically convert any 96 kHz signals to 48 kHz so your system can decode them.

If your receiver or amplifier is capable of handling

96 kHz signals, select [96 kHz]. When this choice is made, this unit will pass each type of signal through without any further processing.

DRC (Dynamic Range Control)

With the DVD format, you can hear a program’s soundtrack in the most accurate and realistic presentation possible, thanks to digital audio technology. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). Then, you may listen to a movie at a lower volume without losing clarity of sound. Set DRC to [ON] for this effect.

Vocal

Set Vocal to [ON] only when a multi-channel karaoke DVD is playing. The karaoke channels on the disc will mix into normal stereo sound.

Hookup and Settings