Presetting the XM Satellite Radio Stations

Presetting the XM Satellite Radio Stations

You can preset 50 stations for XM. Before tuning, make sure that you have turned down the volume.

1.Press TUNER to select XM band.

2.Use XM CH (-/+) on the Remote Control to select the desired channel.

3.Press PROG/MEMO. on the Remote Control.

4.Press PRESET (-/+) on the Remote Control to select the preset number you want.

5.Press PROG/MEMO. on the Remote Control again.

The station is stored.

6.Repeat steps 2 to 5 to store other stations.

To clear all the stored stations

Press and hold PROG/MEMO. for about two seconds and “ERASE XM” is shown in the display window and then press PROG/MEMO. again, the stations are cleared.

If you have accidentally entered into the "ERASE XM" mode and you do not wish to clear the memory, do not press any key. After a few seconds, the "ERASE XM" display will go off by itself and change to normal mode.

Channel Selection

Preset Search

Use PRESET (-/+) on the Remote Control repeatedly to select the preset station you want.

Direct Tuning

1.Using Numeric button on Remote Control, select channel number directly.

2.Press ENTER after more than one numeric key input, system moves to new channel immediately.

Channel up/down

Use XM CH (-/+) repeatedly to select the channel you want.

Category Search

1.Select the Category Search mode using the CAT key on the Remote Control.

(CAT Icon Blinking in Category Search mode.)

2.PRESET (-/+) changes target of category for search, XM CH - or XM CH + selects next channel of selected category in category search mode.

Note:

Category type of current channel displays for 3 seconds when category key is inputted in not category display mode

Category search mode is released below case.

•CAT is inputted in Category search mode.

•No input of PRESET (-/+), XM CH - or XM CH + key for 15 seconds.

Advisory Message

ANTENNA	XM Passport System is not
	connected
	•	Check the connection of XM
		Passport System

SVC ANT	XM Passport System does not
	work properly
	•	Need service of XM Passport
		System

UPDATING	XM Passport System is not
	activated, or User does not have
	authorization for specific channel
	•	Subscribe activation of XM
		Passport System

NO SIGNAL	Receiving signal is too weak
	•	XM Passport System to south
		window for best reception

OFF AIR	Selected channel is not
	broadcasting currently.
	•	Check programming list, select
		another channel.

LOADING	XM Passport System is now
	decoding channel.
	•	Wait completion of decoding
		process

XM---	Selected channel is not available.
	•	Check programming list, select
		another channel.

--------	Channel label or Song name/Artist
----/----	name or Category name is not
--------	available