VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Reboot: Press and release the indented reset button. All status LED will extinguish and then power on again. Wait for the Status LED to blink and then become steady green in normal state. It takes about 30 seconds to complete the procedure.
Restore: Press the reset button continuously for over 3 seconds. All status LED will extinguish and then power on again. Wait for the Status LED to blink and then become steady green in normal state. Note that all settings will be restored to factory default. It takes about 50 seconds to complete the procedure.
Power | POE Status HDD WAN LAN1 LAN2 LAN3 LAN4 | NR7401 Network Video Recorder |
Steady green in normal state
Installation
Hard Disk installation
Before using the Network Video Recorder, the first step is to install a SATA hard disk for re- corded video. Please follow the steps below:
1.Make sure the power is off.
2.Use a screwdriver to loose five screws, and then slide to remove the upper cover.
3.Loose the screw and take out the hard disk bracket.
4.Put your hard disk into the bracket, and secure it with the supplied four screws.
5.Place your hard disk into the Network Video Recorder.
6.Slide the hard disk as the picture shows, and then secure it with the original screw.
7.Attach the upper cover, and then secure it with the original five screws.
2 | 3 |
4 | 5 | 6 |
7
NOTE
► Please remember to format the hard disk before strating recording. Please refer to maintenance on page 37.
User's Manual - 7