2.Remove the Power Cord, Output Bin, 3 Input Rods, and Starter Kit from the box. The Starter Kit includes the Documentation CD, Warranty Card, and Quick Reference Guides. Position the Orbit II in the prepared space.
3. Make sure the switch on the
back of the Orbit II is in the OFF position.
4.Plug the power cord into the back of the Orbit II, then into the nearest power outlet.
NOTE: It is recommended that you do not use an outlet that is already powering other equipment.
Orbit II Stand-Alone DVD and CD Copier
Quick Reference Guide
Basic Duplication
This is a reference for basic operation and duplication only. Please read the manual for more detailed instructions on the advanced features of the Orbit II.
Blank Media Note: Authoring DVD media is not supported
1.Load discs into the Input Hopper. The first
2.Press “Yes” when the display reads “Copy?”
3.Place the Master Disc in the tray when the reader drive opens. See Fig. D below.
4.Press the “Yes” key again to start
duplication. | Fig. C - Loading Procedure |
5. When the input hopper is empty, either |
|
add more discs and press “Yes” to |
|
continue, or press “No” to end the |
|
5.Install the Output Bin on the left side. Extend the bin out to the left until it snaps into position.
6.Install the Input Rods as shown in Fig. B.
7.Turn on the Orbit II.
Please save all packing
materials from your Orbit II!
2 Narrow | Wide |
Input Rods | Input Rod |
| duplication. |
6. | Once the duplication has been |
| completed, the reader drive will eject. |
| Remove the master. |
7. | Remove the copies from the Accept bin |
| on the left. Rejected discs, if any, will |
| be to the right of the Orbit II. |
Fig. D - Reader Drive Ejected
Please refer to the Operator’s Manual for information on the advanced
Fig. B - Input Rod Positions
duplication features of the Orbit II.