Emerson EWR20V4 owner manual VCR/DVD recorder Switching, Editing

Page 9

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Before you

Install two AA batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of battery together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Use within the operating range and angle as shown.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

Within about 23feet (7m)

60˚

Remote control

start Connections Getting started Recording Playing discs

VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com- ponent you wish to operate with the SELECT button.

Editing

VCR MODE

Press the VCR button on the remote control. (Verify that the VCR SELECT indicator is lit.)

DVD MODE

Press the DVD button on the remote control. (Verify that the DVD SELECT indicator is lit.)

Note

•Pressing only the SELECT button on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control.

•Pressing the SETUP or the TIMER PROG. button switches the unit to the DVD mode.

VCR SELECT

SELECT button

 

POWER REC SPEED AUDIO

OPEN/CLOSE

 

.@/:

ABC

DEF

 

 

1

2

3

 

 

GHI

JKL

MNO

CH

 

4

5

6

 

 

PQRS

TUV

WXYZ

VIDEO/TV

 

7

8

9

 

VCR button

 

SPACE

 

SLOW

 

0

 

 

 

DISPLAY

VCR

DVD

PAUSE

DVD button

 

 

 

 

 

 

PLAY

 

 

 

STOP

 

DVD

REC/OTR

SETUP

 

TIMER PROG.

DVD SELECT

REC MONITOR

 

ENTER

 

indicator

MENU/LIST

TOP MENU

 

RETURN

VCR SELECT

CLEAR/C-RESET

ZOOM

SKIP

SKIP

SEARCH

CM SKIP

 

 

indicator

MODE

 

 

 

 

 

 

Changing the SETUP menu VCR functions Others Español

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Menu VCR functions Others Español Supplied AccessoryLaser Safety PrecautionsBefore you start Model No Serial NoPrecautions cont’d Before youS2898A Maintenance Installation LocationMoisture Condensation Warning About CopyrightTable of contents Recording FeaturesPlay Editing222120191817 Functional overview1211 StartFunctional overview cont’d Changing the Setup menu VCR functions Others Español VCR/DVD recorder SwitchingStart Connections Getting started Recording Playing discs EditingSETUP/DISC/CD menu Display menu Details are on Indicates a disc type and a format modeFirst DVD First VCRDisc type and Current status of the unit Display messageRecording speed Title/Track and Chapter markConnection to a TV ConnectionsSupplied Connection to a cable box or satellite boxTo select channels of the cable box or satellite box To playback a DVD disc or a tapeConnection to an Audio System Easy DVD recording Getting startedChannel Easy DVD recording Cont’dGetting channels auto- matically Channel settingSelect Manual Preset using Buttons, then press Enter button Channel setting cont’dManual Preset menu will appear Select Channel using K / L Buttons, then press Enter buttonOption window will appear Selecting the TV stereo or SAPOutputs main-audio Secondary Audio ProgramAuto Clock Setting Clock settingManual Clock Setting Clock setting cont’dSelect OFF using K / L buttons, then press Enter button Clock menu will appear, then the settings will be activatedSetting the daylight sav- ing time Select on or OFF using Buttons, then press Enter buttonDaylight Saving Time options will appear Refer to the Note on this Selecting the TV aspect ratioIf you have a standard TV If you have a widescreen TVInformation on DVD recording RecordingInformation Recording speedInformation on DVD recording cont’d Disc type ModeInformation on copy control Making discs playable in other DVD player FinalizeSETUP/DISC menu will appear Screen Settings for the recording format to a blank discSelect Setup using / B Setup Menu Setup RecordingDefault Select Auto Chapter usingPress Setup button to exit Setup menu Formatting a disc cont’dSelect Format using K / L buttons, then press Enter button Select Yes using / B but- tons, then press Enter but- tonReformatting a disc Formatting is completeBasic recording Checking the recording picture quality Basic recording cont’dXP SP LP First DVD Press REC Monitor button again to exitOne-touch timer recording Timer recording Select a recording speed using K / L buttons Timer recording cont’dPress Enter button when all information required is entered Press Power button to turn offPriority of overlapped settings Hints for timer recordingSettings for an external source Connection to an external sourceSelect the input jack type to connect, then Select a recording speed using REC Speed button. Refer to Settings for an external source cont’dRecording from an external source Recording speed on page 26 for DVD or page 94 for VCRInstructions continue on Dubbing ModeMake sure to select a recording Speed using REC Speed buttonPress VCR VCR to DVD duplication will startFinalizing the discs Select Disc using / B buttons, then press Enter buttonSelect Yes, then press Enter button Finalizing is completeSetting a disc to protect Disc will be protected58% Writing to Disc Information on DVD play Playing discsPlayback Basic playbackFor MP3 playback Basic playback cont’dPlaying discs using the disc menu First DVD Press TOP Menu button Playing discs using the title menuTOP Menu button Press TOP Menu button to exit the title menuSpecial playback Resume playFast forward / Fast reverse Skipping TV commercials during play Special playback cont’dPause During playback, press CM Skip buttonSlow forward / Slow reverse play Step by step playbackPress Skip G button repeatedly To play step by step back- wardZoom Marker SetupUsing Display button Using Skip H / G buttonsSearch Title/Chapter searchTrack search Search cont’dTime search Able only in the same track orRepeat/Random/Program play Repeat playRandom play Repeat/Random/Program play cont’d Select Program Play using Buttons, then press Enter buttonProgram play Press Play B button to start program playbackSwitching audio soundtrack DVD-Video Audio soundtrack will switch. DVD-RW VR modeSelecting the format of audio and video Selecting the format of audio and video cont’d Switching subtitlesSelect a desired option using Buttons, then press Switching camera anglesSelect Icon using / B Reducing block noiseEditing Editing discs in Video modeInformation on disc editing Guide to a title listInformation on disc editing cont’d Editing discs in VR modeEditing original titles Editing playlistsSelect a desired title using K Editing DVD-RW discs in Video modeFirst DVD Press Setup button. Select Deleting titlesPutting names on titles Editing DVD-RW discs in Video mode cont’dThis operation may take a Name you entered will be activated for the titleSelect Chapter Mark using Setting or clearing chapter markersButtons, then press Enter button Chapter marker will be addedOriginal menu will appear Editing DVD-RW discs in VR mode OriginalOriginal list will appear To exit Disc menuDeleting parts of titles Editing DVD-RW discs in VR mode Original cont’dSelect Delete using K / L buttons, then press Enter button Name you entered will be Window for entering a title name will appearActivated for the title Select Chapter Mark using Buttons, then press Enter button Enter button Original menu will appearOption window will appear Add Selected will be deleted Setting pictures for thumbnailsDelete While to be completedButton Ton Pleted, press Setup buttonPicture for thumbnail will be SetSetting titles to protect First DVD Select a desired title using K Titles protecting feature once pro- tectedReleasing titles from protecting You are allowed to releaseSelect PlayList using / B buttons, then press Enter button Editing DVD-RW discs in VR mode PlaylistPlaylist menu will appear Playlist will appearCursor will move to Preview Editing DVD-RW discs in VR mode Playlist cont’dPlaylist will appear Original/PlayList menu will appear ScreenStart Connections Select Edit Title Name using K / L buttons, thenGetting started Recording Disc Edit Playlist Edit Title NameDisc Setting Select Edit using K / L but- tons, then press Enter but Playlist will appear Picture for thumbnail will be Adding titles to a Playlist Playlist as you prefer Select Add New Title usingYou can add or delete a title B buttons, thenDeleting a Playlist Playlist can be deleted if no longer neededPlaylist will be erased Select Title Delete using K Editing DVD-R discsYou cannot select Chapter Mark Editing DVD-R discs cont’d Select Yes using / B but- tons, then press Enter but TonTour of the Setup menu Changing the Setup menuPress Setup button to display SETUP/DISC menu Settings for LanguageSettings for Language cont’d Setup Display Settings for DisplayOSD Background Transparency Default 35% Settings for Display cont’dOSD Background Color Default 1 Green OSD Language Default English Set the language for OSDSettings for Audio Settings for Audio cont’d Settings for Parental lock level Settings for Parental lock level cont’d Press Stop button when the recording is completed Recording and One-touch timer recordingVCR functions PlaybackOne-touch timer recording Index searchTape When you playback a tape recorded in Hi-Fi stereo Counter ResetOther operations Press g/h buttons to start time searchTroubleshooting Symptom RemedyOthers Playback Troubleshooting cont’dBefore you start Connections Getting started Cause SolutionRF converter output Select channel 3 on your TVPress VIDEO/TV button on the remote con- trol Language code 101Language Code Glossary General SpecificationsFácil grabación de DVD EspañolPuede editar lo siguiente de la lista de títulos ¿Qué son títulos y capítulos?Original y Playlist modo VR ¿Qué significa Original o Playlist?Presione VCR Reproducción con videograbadoraGrabación con temporizador de un toque GrabaciónLimited Warranty
Related manuals
Manual 2 pages 60.16 Kb
Top Page Image Contents