B) Concrete / Brick Installation
NOTE: The concrete anchors must be used for concrete installation.
1Attach the bubble level (G2) to the wall plate, with the help of an assistant place the wall plate into position against the wall, using the bubble level to keep it level.
2Mark four holes to be used for securing the mount and place the wall plate aside.
3Next, drill holes using an electric drill and 5/16" masonry bit to a depth of approximately 2".
4Insert a concrete anchor (F) into each hole. If necessary, a hammer can be used to lightly tap each anchor into place so that they are flush with the wall.
5Once all of the anchors are in place, move the wall plate back into position. Check the bubble level to verify that the wall plate is level.
6Insert bolt (E) with washer (G1) into each concrete anchor in the wall. Do not tighten until all bolts are in place.
7Tighten the bolt with a 7/16" socket or open ended wrench by turning clockwise until tight.
Step 2 Display Bracket Installation
1To ensure optimal installation, this kit includes various screws of different diameters and lengths.
2Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display.
3Determine which screw (A1/A2/B1/B2/C1/C2) is the correct length by carefully inserting a straw, or toothpick, and mark how deep the mounting point is.
4According to the size of display's hole, choose the corresponding screw and hole on the rectangle washer, then thread them in line as shown.
5If your display has a curved back or a recessed thread mounting point, place a spacer (H) between the mounting bracket and display. Then choose a screw (A2/B2/C2) to match.
4