SIIG 04-0621A installation instructions Concrete / Brick Installation, Display Plate Installation

b) Concrete / Brick Installation

Note: The concrete anchors must be used for concrete and brick installation.

1	Begin by placing the wall plate into position against the wall, using the
	bubble level to keep it level. Locate the holes directly into the block or
2	concrete, never into the mortar between the blocks (Figure 2).
	Mark six holes to be used for securing the mount and place the wall
	plate aside.
3	Drill six holes using an electric drill and 1/2" masonry bit to a depth of
	2" at the positions you marked.
4	Insert a concrete anchor (G) into each hole.
5	If necessary, a hammer can be used to lightly tap each concrete
	anchor into place so that they are flush with the wall.
6	Once all of the concrete anchors are in place, move the wall plate
	back into position.
7	Insert bolts (H) and washers (J) into the concrete anchor as shown
	(Figure 2) and tighten. Do not fully tighten until all screws are in place.	Figure 2

Step 2 Display Plate Installation

Note: The installation kit includes screws of various diameters and lengths to ensure optimal installation.

1Place your TV screen down on a soft, flat surface, and locate the threaded mounting points that are located on the back of the display (Figure 3).

2Determine which screw (A/B/C/D/E/F) is of the correct length by carefully inserting a straw or toothpick, and mark how deep the mounting point is (Figure 4 & 4-1).

3If your display has a curved back or a recessed thread mounting point, a spacer (K) must be used. Then choose screw (D/E/F) to match. Place the spacer (M) between the mounting bracket and display (Figure 4-1).

4According to the size of display's hole, choose the corresponding screw (A/B/C/D/E/F) and hole on the rectangular washer (I), then thread them in line (Figure 4 & Figure 4-1).

Figure 3 Figure 4 Figure 4-1

4