09. Color (Command:i)
GTo adjust the screen color.
You can also adjust color in the Picture menu.
Transmission
[k][i][ ][Set ID][ ][Data][Cr]
Data Min : 0 ~ Max : 64
•Refer to ‘Real data mapping 1’. See page 27. Acknowledgement
[i][ ][Set ID][ ][OK][Data][x]
10. Tint (Command:j)
GTo adjust the screen tint.
You can also adjust tint in the Picture menu.
Transmission
[k][j][ ][Set ID][ ][Data][Cr]
Data Green : 0 ~ Red : 64
•Refer to ‘Real data mapping 1’. See page 27.
Acknowledgement
[j][ ][Set ID][ ][OK][Data][x]
11. Sharpness (Command:k)
GTo adjust the screen sharpness.
You can also adjust sharpness in the Picture menu.
Transmission
[k][k][ ][Set ID][ ][Data][Cr]
Data Min: 0 ~ Max: 64
•Refer to ‘Real data mapping 1’. See page 27. Acknowledgement
[k][ ][Set ID][ ][OK][Data][x]
12. OSD Select (Command:l)
GTo select OSD (On Screen Display) mute on/off.
Transmission
[k][l][ ][Set ID][ ][Data][Cr]
Data 0: OSD mute on | 1: OSD mute off |
Acknowledgement
[l][ ][Set ID][ ][OK][Data][x]
13. Key Lock (Command:m)
GTo lock the remote control and the front panel controls on the TV.
Transmission
[k][m][ ][Set ID][ ][Data][Cr]
Data 0: Lock off | 1: Lock on |
Acknowledgement
[m][ ][Set ID][ ][OK][Data][x]
•If you’re not using the remote control and front panel controls on the monitor, use this mode. When main power is on/off, remote control lock is released.
14. Tune Command (Command:m a)
GTune channel to following Physical/major/minor number.
Transmission
[m][a][ ][Set ID][ ][Data0][ ][Data1][Cr]
Data0: Channel Number
Min : 1 ~ Max : 0x7D(transmit by Hexadecimal code)
Acknowledgement
[a][ ][Set ID][ ][OK][Data0][Data1][x] [a][ ][Set ID][ ][NG][Data0][x]
15. Channel Add/Del (Command:m b)
GTo add and delete the channels.
Transmission
[m][b][ ][Set ID][ ][Data 0][Cr]
Data0:
Acknowledgement
[b][ ][Set ID][ ][OK][Data0][x] [b][ ][Set ID][ ][NG][Data0][x]
16. Key (Command:m c)
GTo send IR remote key code.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data: Key code- Refer User’s Manual
Acknowledgement
[c][ ][Set ID][ ][OK][Data][x]
17. Auto Configure (Command:j u)
GAutomatically adjusts the screen position, clock and clock phase.
Transmission
[j][u][ ][Set ID][ ][Data][Cr]
Data 1: To set
Acknowledgement
[u][ ][Set ID][ ][OK][Data][x]
28