|
| ASSEMBLING AND PREPARING 13 | ||
Mounting on a table |
|
| ||
| Adjusting the angle of the TV to suit view |
| ||
Swivel 20 degrees to the left or right and adjust
1 Lift and tilt the TV into its upright position on a the angle of the TV to suit your view. table.
- Leave a 10 cm (4 inches) (minimum) space |
|
| |
from the wall for proper ventilation. | 20 | 20 | |
10 | cm (4 inches) |
|
|
10 cm | 10 | cm |
| ||
|
| |
| 10 cm | |
|
| CAUTION | |
|
| yyWhen adjusting the angle of the TV, | |
|
| watch out for your fingers. | |
|
| - Personal injury may occur if hands or | |
2 | Connect the power cord to a wall outlet. | fingers are pinched. If the product is | |
tilted too much, it may fall, causing | |||
|
|
CAUTION
yyDo not place the TV near or on sources of heat, as this may result in fire or other damage.
damage or injury.
Tidying cables
ENGLISH
Securing the TV to a table
(For 47LS4600, 32/37/42/47LS5600, 42/47LS5650) Fix the TV to a table to prevent from tilting forward, damage, and potential injury.
To secure the TV to a table, insert and tighten the supplied screw on the rear of the stand.
WARNING
yyTo prevent TV from falling over, the TV should be securely attached to the floor/wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.
1Gather and bind the cables with the cable holder.
Cable holder
CAUTION
yyDo not move the TV by holding the cable holder, as the cable holders may break, and injuries and damage to the TV may occur.