LG Electronics DU-60PY10 owner manual CableCARDTM Setup, Hdstb Setup, Digital Set-top Box

Installation

CableCARDTM Setup

How to use

Insert the CableCARDTM received from Cable Service provider to CableCARDTM slot of TV back panel.

If Host or CableCARDTM does not display on the screen, contact with Cable service provider by phone.

Note :

•CableCARDTM has the types of Motorola, Scientific Atlanta, SCM etc.. These 3 types of CableCARDTM can be used for this PLASMA TV.

Caution: When removing the CableCARDTM, do not fall it as this may cause impact to the CableCARDTM.

Cable

ANTENNA CABLE

AC INPUT

HDSTB Setup

-This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below.

-This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).

HDMI /	DIGITAL AUDIO(OPTICAL)
DVI(VIDEO)	COMPONENT2
DVI

AUDIO INPUT	VIDEO INPUT	Cable
		ANTENNA	CABLE

AC INPUT

or or

RGB-DTV OUTPUT (R) AUDIO (L)

or

or

(R) AUDIO (L)	DIGITAL AUDIO	DVI-DTV OUTPUT HDMI-DTV OUTPUT	DIGITAL AUDIO	(R) AUDIO (L)	B	R
	OPTICAL		OPTICAL

Digital Set-top Box

How to connect

Use the TV’s COMPONENT (Y, PB, PR) INPUT, RGB or HDMI/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections.

How to use

1.Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)

2.Use TV/VIDEO or COMP/RGB/HDMI on the remote control to select Component 1, Component 2, RGB-DTV, or HDMI/DVI source.

Signal	Component 1/2	RGB-DTV,HDMI/DVI
480i	Yes	No
480p	Yes	Yes
720p	Yes	Yes
1080i	Yes	Yes

16 Plasma TV