LG Electronics 50PG30C, 60PG30C, 42PG20C Exposed to dripping or splashing and no, Grounding

Page 5

10 Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.

11

Never touch this apparatus or antenna during

 

a thunder or lighting storm.

 

 

12

Do not allow a impact shock or any objects to

 

fall into the product, and do not drop onto the

 

screen with something.

 

 

13

Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has exposed to rain or moisture, does not operate normally, or has been dropped.

15 Outdoor use marking :

WARNING - To reduce the risk of fire or elec- tric shock, do not expose this appliance to rain or moisture.

16

Wet Location Marking : Apparatus shall not be

 

exposed to dripping or splashing and no

objects filled with liquids, such as vases, shall be placed on or over apparatus.

14 CAUTION concerning the Power Cord :

Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain.

Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates dam- age or deterioration, unplug it, discontinue use

17 GROUNDING

Ensure that you connect the earth ground wire to prevent possible electric shock. If grounding methods are not possible, have a qualified electrician install a separate circuit breaker.

Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes.

Power

Supply

Short-circuit

Breaker

18 DISCONNECTING DEVICE FROM MAINS

Mains plug is the disconnecting device. The plug must remain readily operable.

3

Image 5
Contents When you require service No SAC30708031 0805-REV03 Page FCC Notice Important Safety Instructions Safety InstructionsGrounding Disconnecting Device from MainsExposed to dripping or splashing and no Contents External Control Through RS-232C Auto Volume Leveler Auto VolumeClock Setting Feature of this TV Preparation AccessoriesPreparation Volume Channel Power Input MenuVolume Front Panel InformationBack Panel Information Stand Instruction InstallationDetachment Protection CoverCable Management How to remove the Cable Management ClipSwivel Stand Only 50/60PG30, 50/60PG30C Desktop Pedestal Installation400 Vesa Wall MountingSame Securing the TV to the Wall to Prevent FallingAntenna Analog or Digital Antenna or Cable ConnectionHD Receiver Setup External Equipment SetupHow to connect How to useHDMI-DTV SetupHdmi Connection Connect the DVI output of the digital set-top box to DVI to Hdmi ConnectionHDMI/DVI IN1, 2, or Hdmi IN3 jack on Audio RGB/DVI jack on the TVConnect the audio outputs of the DVD to DVD SetupComponent in AUDIO1 jacks on the TV External EquipmentConnect the S-VIDEO output of the DVD to Video ConnectionVideo input on the TV Input jacks on the TVAntenna Connection VCR SetupComposite RCA Connection Button on the remote controlIf you have a mono VCR, connect the audio cable From the VCR to the Audio L/MONO jack of the TVAudio OUT Connection Other A/V Source SetupConnect the PC audio output to PC SetupAudio RGB/DVI jack on the TV720x400 31.469 31.46837.500 37.861Selecting Resolution Screen Setup for PC modeEquipment Setup ExternalCan adjust the Position, S i z e or Phase Auto ConfigureSelect Auto config Adjustment for screen Position, Size, and Phase Select Yes Screen Reset Reset to original factory valuesSelect Reset Remote Control Functions Watching TV / Channel Control Installing BatteriesChannel Selection Volume AdjustmentTurning on TV Mode Setting Initial SettingTime Setting Auto TuningQuick Menu Display each menu Make appropriate adjustmentsWatching TV Channel ControlTV / Channel Control ON-SCREEN Menus SelectionFor USA Display each menuAuto Scan Auto Tuning Channel SetupWatching TV / Channel Select ChannelSelect Manual Tuning Add/Delete Channel Manual TuningSelect channel you want to add or delete Select Add or DeleteChannel Editing Select the desired input source Input ListWith using Input button With using Option menuInput Label Select Input LabelYou can select the optimal images and sounds AV ModeWatching TV / Channel Select OptionSimplink Menu Simplink FunctionsPicture Control Picture ControlPicture Size Aspect Ratio Control 169 Picture Mode Preset Preset Picture SettingsColor Tone Preset Picture Manual Picture AdjustmentPicture Mode User Mode Off Picture Mode Standard Picture Mode Expert ControlPicture Improvement Technology Low The reflection of the screen gets Darker Advanced Control Black Darkness LevelAdvanced Control Film Mode Initialize the adjusted value Picture ResetUtes Image Sticking Minimization ISM MethodEvery 30 minutes White Wash White Wash removesIt reduces the plasma display’s power consumption Power Saving Picture ModeSelect Auto Volume Auto Volume Leveler Auto VolumeSound & Language Control Sound & Language ControlLanguage Control Clear VoiceSound Sound Select Standard, Music, Cinema, Sport, or Game Preset Sound Settings Sound ModeAdjust the sound to suit your taste and room situations Sound Setting Adjustment User ModeSelect Sound Mode Select Standard, MusicBalance Turn the TV speakers off if using external audio equipment TV Speakers ON/OFF SetupAudio Reset Digital TV STEREO/SAP Broadcast SetupAnalog TV Select your desired language English, Spanish, or French Audio LanguageMenus can be shown on the screen in the selected language ON-SCREEN Menus Language SelectionSelect Language Select Menu Select your desired language Return to the previous menu Return to TV viewingAnalog Broadcasting System Captions Caption ModeCaption TextDigital Broadcasting System Captions Select CC1-4, Text1-4, or Service1Size Set the word size Caption OptionClock Setting Time SettingAuto Clock Setup Time SettingIf the current time setting is wrong, set the clock manually Manual Clock SetupSelect Time Auto ON/OFF Time SettingOnly for On Time function Select Off time or On timeSleep Time turns the TV off at the preset time Sleep Timer SettingAuto SHUT-OFF Setting Setting up Your Password SET Password & Lock SystemParental Control / Ratings Chip rating and categoriesSelect Lock System Is enableLock System Control / Rating Set PasswordParental Block Channel Channel BlockingMovie & TV Rating Select Lock Input the password General audienceMovie Rating Mpaa For USA only PG-13 Parents strongly cautionedTV Rating Children For USA only TV Rating General For USA only Selecting canadian english language rating system TV Rating English For Canada onlySelect Lock Select TV Rating-EnglishSelecting canadian french language rating system TV Rating French For Canada onlySelect E, G, 8ans+, 13ans+ 16ans+, 18ans+, or Blocking offDownloadable Rating External Input Blocking Enables you to block an inputKEY Lock Remote control Doesn’t work Power is suddenly Turned off TroubleshootingAppendix AppendixVertical bar or stripe on Background Audio function does not workProduct Specifications MaintenanceCleaning the Screen Cleaning the CabinetModels IR Codes Remote Control IR Codes1st frame Repeat frameCode Function External Control Through RS-232C RS-232C SetupCommunication Parameters GNDRXD TXD GND DTR DSR RTS CTS RS-232C ConfigurationsEither cable below can be used Transmission / Receiving Protocol Command Reference ListSet ID DataCr Transmission km Set ID DataCr Step