LG Electronics 32LT560E, 47LT560E, 42LT560E, 42LT560C, 37LT560E, 37LT560C, 22LT560C Table of Contents

Page 7

TABLE OF CONTENTS 7

TABLE OF CONTENTS

2 LICENSES

2OPEN SOURCE SOFTWARE NOTICE

3IMPORTANT SAFETY INSTRUCTIONS

7TABLE OF CONTENTS

8INSTALLATION PROCEDURE

8 ASSEMBLING AND PREPARING

8 Unpacking

10Optional Extras (For LT560E series)

11Parts and buttons

12Setting up the TV

12- Attaching the stand

14- Mounting on a table

15- Mounting on a wall

17- Tidying cables

17- External speaker out

18 REMOTE CONTROL

20GENERAL TROUBLESHOOTING

20CAUTION for using ezsign 2.0

21SPECIFICATIONS

23IR CODES

24EXTERNAL CONTROL DEVICE SETUP

24RS-232C Setup

24Type of connector; D-Sub 9-Pin Male

25RS-232C configurations

26Communication Parameters

26Command reference list

27Transmission / Receiving protocol

ENGLISH

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and the receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.

Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Image 7
Contents LED LCD TV Open Source Software Notice LicensesImportant Safety Instructions English Electrical Code, ANSI/NFPA Antenna grounding according to the NationalYyDot Defect Table of Contents Assembling and Preparing Installation ProcedureUnpacking English Optional Extras For LT560E series Button Description Parts and buttonsAttaching the stand Setting up the TVTop View Mounting on a table Optional ModelStandard screw Optional ModelLocal dealer Tidying cables Number button Remote ControlDash Color buttons OK ꔉBack Exit ꕯSymptom Possible Causes Possible Solutions General Troubleshooting47LT560E-UA SpecificationsResolution Horizontal Vertical RGBPC, Hdmi PC supported modeCode Function Hexa IR CodesRS-232C Setup External Control Device SetupType of connector D-Sub 9-Pin Male Wire ConfigurationsNot standard RS-232C configurationsCommunication Parameters Command reference listTransmission / Receiving protocol Command1Command2 Set ID DataCrInput Select Command x b Power Command k aVolume Control Command k f To adjust volume Bass Command k s To adjust bass OSD Select Command k lRemote Control Lock Mode Command k m Treble Command k r To adjust trebleChannel Tuning Command m a Energy Saving Command j qAuto Configuration Command j u Channel Add/Del Command m b Key Command m cStep Main/Sub Two/One UsingPage Page Page Child Safety LG Customer Information Center