U514Aen 98/2/18 4:26 AM Page 14
External Equipment Connections
PC Setup
NOTE: All cables shown are not included with the Monitor
How to connect
1.To get the best picture quality, adjust the PC graphics card to 1024x768, 60Hz. But in 42PM3MV series, we recommend using 640x480, 60HZ for the PC mode.
2.Use the set’s RGB INPUT or HDMI/DVI (VIDEO) INPUT port for video connections, depending on your PC connector.
•If the graphic card on the PC does not output analog and digital RGB simultaneously, connect only one of either RGB INPUT or HDMI/DVI (VIDEO) to display the PC on the set.
•If the graphic card on the PC does output analog and digital RGB simultaneously, set the set to either RGB or HDMI/DVI (VIDEO); (the other mode is set to Plug and Play automatically by the set.)
3.Then, make the corresponding audio connection. If using a sound card, adjust the PC sound as required.
How to use
|
| REMOTE | RGB OUTPUT |
|
| CONTROL | |
HDMI/ |
|
| |
(CONTROL/SERVICE) | DVI(VIDEO) | AUDIO INPUT | RGB INPUT |
1.Turn on the PC and the set.
2.Turn on the display by pressing the POWER button on the set's remote control.
3.Use INPUT or MULTIMEDIA on the remote control to select RGB or HDMI source.
4.Check the image on your set. There may be noise associated with the resolution, vertical pattern, contrast or brightness in PC mode. If noise is present, change the PC mode to another resolution, change the refresh rate to another rate or adjust the brightness and contrast on the menu until the picture is clear. If the refresh rate of the PC graphic card can not be changed, change the PC graphic card or consult the manufacturer of the PC graphic card.
Note:
Notes: | - When Source Devices connected with HDMI/DVI Input, |
- Depending on the graphics card, DOS mode may not | output TV SET Resolution(480p, 720p, 1080i) and SET |
work if a HDMI to DVI Cable is in use. | Display fit |
- Avoid keeping a fixed image on the screen for a long peri- | refer to the Manual of HDMI/DVI Source Devices or con- |
od of time. The fixed image may become permanently | tact your service center. |
imprinted on the screen. Use the Orbiter feature on the | - In case HDMI/DVI Source Devices is not connected |
ISM Method menu. | Cable or poor cable connection, "No signal" OSD dis- |
- When Source Devices connected with HDMI/DVI Input, | play in HDMI/DVI Input. In case that Video Resolution is |
output PC Resolution(VGA, XGA), Position and Size | not supported SET output in HDMI/DVI Source Devices, |
may not fit the Screen. | "Invalid Format" OSD display. Refer to the Manual of |
| HDMI/DVI Source Devices or contact your service cen- |
| ter. |
14 Plasma Monitor