LG Electronics 37500H, 42LC50C Stand Installation, Clip and snap it closed, Stand Body Cover Base

32/37/42LG500H

BACK COVER FOR WIRE ARRANGEMENT

1Connect the cables as necessary.

To connect additional equipment, see the EXTERNAL EQUIPMENT SETUP section. Secure the power cable with the PLUG IN TYPE HOLDER for power code and PROTECTIVE BRACKET/Screw. It will help prevent the power cable from being removed by accident.

STAND INSTALLATION

1Carefully place the TV screen side down on a cush- ioned surface to protect the screen from damage.

2Assemble the parts of the STAND BODY with COVER BASE of the TV.

PREPARATION

PLUG IN TYPE HOLDER

PROTECTIVE BRACKET

(This feature is not available for all models.)

2Install the CABLE MANAGEMENT CLIP as shown. If your TV has the CABLE HOLDER, install it as shown and bundle the cables.

CABLE MANAGEMENT CLIP

CABLE HOLDER

3Put the cables inside the CABLE MANAGEMENT

CLIP and snap it closed.

PROTECTION COVER

After removing the stand, install the included protection cover over the hole for the stand.

Press the PROTECTION COVER into the TV until you hear it click.

STAND BODY

COVER BASE

3Assemble the TV as shown.

4

x 4

Tighten the stand with the four screws (provided as parts of the TV).

or

x 2	Tighten the two of these four screws
	x 2 and thetwoTorxplusstarheadscrews

(provided as parts of the TV) to secure the TV. Tighten the two Torx plus star head screws with a star head dri- ver bit (not provided as parts of the TV).

!NOTE

GWhen assembling the desk type stand, make sure the bolt is fully tightened (If not tightened fully, the TV can tilt forward after the product installa- tion). Do not over tighten.

15