LG Electronics 425010, 425030, 425020 Set the shipping mode In-stop, Select the option by country

6.3 Reference

(White Balance adjustment coordinate and White balance)

OBrightness: Full white 216 Gray

8.Set the shipping mode (In-stop)

-After completing the final test, in order to set the set to the shipping condition, press the In-Stop key of the R/C to make sure that the set is turned off.

OStandard color coordinate and white balance when using the CS-1000

O Standard color coordinate and white balance when using the CA-210 (CH 10)

7. Select the option by country

7.1 Overview

-The option selection is applied to the North American model only, which selects the rating related country.

-Applied models: LA84A Chassis applied None USA Model(Canada, Mexico)

7.2 How to select

1)Press the In-Start key of the R/C and press the red oval OP1(PIP CH-) key to enter into the Factory Option menu.

2)Select 1.USA, 2.CANADA or 3.MEXICO from the country select according to the destination. At this time, use the volume +/- key to adjust

9. GND and resisting pressure test

9.1 How to test

1)Preparing for the automatic test on the GND & resisting pressure

-Make sure that the power cord is completely inserted into the set. (When it is disconnected or loosened, test after inserting it)

2)Perform the automatic test on the GND & resisting pressure

-The set with power cord, the cord and the A/V completely inserted into the tuner is loaded on the pallet and entered into the automatic test process.

-Connect the D-terminal AV JACK tester

-Turn on the automatic (GWS103-4)

-Perform the GND TEST

-If it is not good, the buzzer is operated to notify the test result to the operator.

-If it is OK, it is automatically switched to the resisting pressure test. (Disconnect the cord and the A/V from the

AV JACK BOX)

-Perform the resisting pressure test

-If it is not good, the buzzer is operated to notify the test result to the operator.

-If it is OK, the GOOD LAMP is turned and the stopper is moves down, and it moves to the next process.

9.2 Items to manage

OTEST voltage

-GND:1.5KV/min at 100mA

-SIGNAL:3KV/min at 100mA

OTEST time:1 second

OTEST POINT

-GND TEST = between POWER CORD GND and

SIGNAL CABLE METAL GND

-Resisting pressure TEST = between POWER CORD GND and LIVE & NEUTRAL

OLEAKAGE CURRENT: Set to 0.5mArms