18ASSEMBLING AND PREPARING
Mounting on a table
1Lift and tilt the TV into its upright position on a table.
-Leave a 10 cm (4 inch) (minimum) space from the wall for proper ventilation.
Securing the TV to a table
(For 42CM565)
Fix the TV to a table to prevent from tilting forward, damage, and potential injury. Mount the TV on a table, and then insert and tighten the supplied screw on the rear of the stand.
| 10 | cm(4 | inches) |
|
|
|
|
| |
10 cm |
|
| 10 | cm |
|
|
| ||
|
|
|
| |
|
|
| 10 cm | |
2Connect the power cord to a wall outlet.
ENGLISH |
|
| CAUTION |
| |
|
|
|
|
| |
| yyDo not place the TV near or on sources | ||||
|
| ||||
|
|
| of heat, as this may result in fire or other | ||
|
|
| damage. | ||
|
|
|
| ||
|
| Adjusting the angle of the TV to suit view |
| ||
|
|
|
|
|
|
Swivel 20 degrees to the left or right and adjust the angle of the TV to suit your view.
20 | 20 |
CAUTION
yyWhen adjusting the angle of the TV, watch out for your fingers.
-Personal injury may occur if hands or fingers are pinched. If the product is tilted too much, it may fall, causing damage or injury.
WARNING
yyTo prevent TV from falling over, the TV should be securely attached to the floor/ wall per installation instructions. Tipping, shaking, or rocking the TV may cause injury.
Tidying cables
1Gather and bind the cables with the cable management clip.
2Fix the cable management clip firmly to the TV.
Cable management clip
CAUTION
yyDo not move the TV by holding the cable management clipr, as the cable holders may break, and injuries and damage to the TV may occur.