LG Electronics 5 52 2L LG G5 50, 42 2P PG G3 30, 42 2P PG G2 20, 37 7L LG G3 30, 37 7L LG G5 50 112

Page 114

APPENDIX

01. Power (Command: k a)

GTo control Power On/Off of the TV. Transmission

[k][a][ ][Set ID][ ][Data][Cr]

Data 00 : Power Off01 : Power On

Ack

[a][ ][Set ID][ ][OK/NG][Data][x]

G To show Power On/Off.

Transmission

[k][a][ ][Set ID][ ][FF][Cr] Ack

[a][ ][Set ID][ ][OK/NG][Data][x]

*Similarly, if other functions transmit ‘0xFF’ data based on this format, Acknowledgement data feed back pre- sents status about each function.

*OK Ack. ,Error Ack. and other message maybe display on the screen when TV is power On.

02. Aspect Ratio (Command: k c) (Main Picture Size)

G To adjust the screen format. (Main picture format)

You can also adjust the screen format using the

Aspect Ratio in the Q.MENU. or PICTURE menu.

Transmission

[k][c][ ][Set ID][ ][Data][Cr]

 

 

Data

01

: Normal screen (4:3)

06

: Original

 

 

 

 

 

02

: Wide screen (16:9)

07 : 14:9

APPENDIX

 

04

: Zoom1

 

09

: Just Scan

 

05

: Zoom2

 

 

 

 

 

 

 

 

 

 

Ack

 

 

 

 

 

 

 

 

 

 

 

[c][

][Set ID][ ][OK/NG][Data][x]

 

 

 

 

 

 

 

 

* Using the PC input, you select either 16:9 or 4:3

screen aspect ratio.

* In HDMI/Component (over 720p) mode, Just Scan is available.

* You can only select Original in UK digital teletext (MHEG-5).

03. Screen Mute (Command: k d) G To select screen mute on/off. Transmission

[k][d][ ][Set ID][ ][Data][Cr]

Data 00 : Screen mute off (Picture on) 01 : Screen mute on (Picture off)

Ack

[d][ ][Set ID][ ][OK/NG][Data][x]

112

04. Volume Mute (Command: k e)

G To control volume mute on/off.

You can also adjust mute using the MUTE button on remote control.

Transmission

[k][e][ ][Set ID][ ][Data][Cr]

Data 00 : Volume mute on (Volume off) 01 : Volume mute off (Volume on)

Ack

[e][ ][Set ID][ ][OK/NG][Data][x]

05. Volume Control (Command: k f)

G To adjust volume.

You can also adjust volume with the VOLUME buttons on remote control.

Transmission

[k][f][ ][Set ID][ ][Data][Cr]

Data Min : 00 ~ Max : 64

* Refer to ‘Real data mapping 1’. See page 114.

Ack

[f][ ][Set ID][ ][OK/NG][Data][x]

06. Contrast (Command: k g)

GTo adjust screen contrast.

You can also adjust contrast in the PICTURE menu.

Transmission

[k][g][ ][Set ID][ ][Data][Cr]

Data Min : 00 ~ Max : 64

* Refer to ‘Real data mapping 1’. See page 114.

Ack

[g][ ][Set ID][ ][OK/NG][Data][x]

07. Brightness (Command: k h)

GTo adjust screen brightness.

You can also adjust brightness in the PICTURE menu.

Transmission

[k][h][ ][Set ID][ ][Data][Cr]

Data Min : 00 ~ Max : 64

* Refer to ‘Real data mapping 1’. See page 114.

Ack

[h][ ][Set ID][ ][OK/NG][Data][x]

08. Colour (Command: k i)

G To adjust the screen colour.

You can also adjust colour in the PICTURE menu.

Transmission

[k][i][ ][Set ID][ ][Data][Cr]

Data Min : 00 ~ Max : 64

* Refer to ‘Real data mapping 1’. See page 114.

Ack

[i][ ][Set ID][ ][OK/NG][Data][x]

Downloaded From TV-Manual.com Manuals

Page 113 Page 115
Image 114
Page 113 Page 115
Contents LCD TV Page Accessories Polishing cloth for use on the screenContents Contents Sound & Language ControlPreparation Front Panel ControlsPreparation LCD TV Models 26/32/37/42LG30**, 32/37/42/47/52LG50 Preparation Connect the output from a PC Back Panel InformationConnect the audio from a PC or DTV Connect a component video/audio device to these jacksConnect S-Video out from an S-VIDEO device Connect the headphone plug to this socketAntenna Stand Installation Back of the TVCover Base of the TV Stand Body Only 42PG10**, 42PG20**, 42PG30 Stand Installation Only 19/22LS4D Cushioned surface to protect the screen from Sound DamageDetaching Stand Only 19/22LS4D Button on the Stand Body Pressing 2 latchesPlease SET IT UP Carefully SO the Product does not Fall Over Back Cover for Wire Arrangement How to remove the cable management clipConnect the cables as neces- sary Fit the Cable Management Clip as shownLCD TV Models 19/22LG30 Positioning Your Display Only 19/22LG30**, 19/22LS4D Tilt rangeCircuit Breaker Plasma TVUntil clicking sound Antenna Connection Wall Antenna SocketConnecting with a component cable External Equipment SetupHD Receiver Setup Connecting a set-top box with an Hdmi cableDigital Audio OUT Setup Connecting with a Hdmi to DVI cableExternal DVD Setup When connecting with a component cableConnecting with a Euro Scart cable Connecting with a S-Video cable Connecting the Hdmi cableSetup VCR Setup When connecting with a RF CableExternal Eqipment If connected to AV2 Euro scart socket, select AV2 Connecting with a RCA cableEqipment Input sourceOther A/V Source Setup Eqipment Setup PC SetupConnecting with a D-sub 15 pin cable Insertion of CI ModuleConnecting with a Hdmi to DVI cable Supported Display Resolution Only 19/22LS4D RGBPC, Hdmipc mode Hdmidtv modeSupported Display Resolution Run Reset Screen Setup for PC modeSelect Reset ScreenSelect Position, Size or Phase Select PictureSelect Screen Selecting Resolution Select ResolutionAuto Configure RGB PC mode only Select PictureWatching TV / Programme Control Watching TV / Programme ControlInstalling Batteries Power Switches the TV on from standby or off to standby OK Accepts your selection or displays the current modeControl Volume UP Except for 19/22LS4D*, 42/50PG10 Move from one full set of screen information to the next UP/DOWN oneVolume Adjustment Turning on the TVProgramme Selection Watching TV On Screen Menus Selection and AdjustmentPicture Programme ControlAuto Programme Tuning Select SetupWatching TV / Programme Manual Programme Tuning in Digital ModeSelect Setup Select DTVManual Programme Tuning in Analogue Mode Watching TV / Programme SetupSelect Setup Select Fine Select Setup Select Manual Tuning Select TV Select NameNormally fine tuning is only necessary if reception is poor Select Manual Tuning Sound Select TV Select StorePassword in Lock System ‘On’ Programme EditDTV/RADIO Mode Gramme numberTV Mode Favourite programme listSelect Booster SaveSoftware Update Watching TV SetupSelect Diagnostics Display the information of ChannelSelect Setup Select CI Information CI Common Interface InformationSelecting the Programme Table Option Select OptionVCR playback Play and control the connected VCR.4Select the source Input LabelSelect Option Select the labelAV Mode Switch on or off EPG EPG Electronic Programme Guide in Digital ModeSwitch on/off EPG Select a programmeButton Function in NOW/NEXT Guide Mode Button Function in 8 Day Guide ModeButton Function in Date Change Mode Button Function in Record/Remind Setting Mode Button Function in Schedule List ModeButton Function in Extended Description Box Picture Size Aspect Ratio Control Picture Control149 Zoom1Preset Picture Settings Picture Mode-PresetSelect Picture Mode Auto Colour Tone Control Warm/Medium/Cool Select either Cool, Medium or WarmManual Picture Adjustment Picture Mode-User optionPicture Mode-Expert Control Select Advanced Control Select your desired SourceAdvanced Film Mode Advanced Blackdarkness Level EYE Care LCD TV only Select Eye CarePicture Reset Initialize the adjusted valueImage Sticking Minimization ISM Method If you do not need this function, set Normal OK SavePower Saving Picture Mode Plasma TV only Sound & Language Auto Volume LevelerSound & Language Control Select AudioPreset Sound SETTINGS-SOUND Mode Select Audio If you select Clear VoiceSound Setting Adjustment -USER Mode SoundLanguage Control Balance Select BalanceTV Speakers ON/ OFF Setup AudioSelect Dolby Digital or Selecting Digital Audio OUTSelect Digital Audio Out PCMAudio Reset Select ResetSelect the sound output Stereo/Dual Reception In Analogue Mode OnlyFor 19/22LS4D * only Sound & Language ControlNicam Reception In Analogue Mode Only Speaker Sound Output SelectionIf you want to change Language/ Country selection Select Menu Language or CountryLanguage Selection in Digital Mode only Select your desired language Select On or Off SaveTime Setting Clock SetupAdjust volume level at Auto ON/OFF Timer SettingSelect Mode Set the hour Switch-on Set the minutesAuto SHUT-OFF Setting TimeTime Zone Setup Sleep Timer SettingTime Setting Select Lock SET Password & Lock SystemParental Control / Ratings Parental Control / RatingsEnter the Block Programme Block ProgrammeSelect Lock Green Select a programme to be lockedParental Control in Digital Mode only KEY Lock Teletext TeletextUpdate RevealHold Digital Teletext Digital TeletextAppendix AppendixTroubleshooting Remote control Does not work Power is suddenly Turned offCheck whether the TV is switched on USB Check Hdmi cable over version Check USB cable over versionInvalid format Vertical bar or stripe on Background Maintenance Cleaning the ScreenProduct Specifications 42PG3000-ZA103 104 Programming the Remote Control Programming a code into a remote modeTesting your remote control Hdstb Repeat frame IR Codes1st frame Bit description108 External Control Device Setup GNDRXD TXD GND DTR DSR RTS CTS Adjustment range of SET ID is 1~99 Select Set IDParity None Use a crossed reverse cable Command Reference ListBaud rate 9600 bps Uart Stop bit 1 bit Data length 8 bits Transmission / Receiving Protocol112 113 114 115
Top Page Image Contents