LG Electronics 32PC5DVC owner manual Code Remote control

APPENDIX

APPENDIX

24. Auto Configuration (Command: j u)

To adjust picture position and minimize image shaking automatically. Auto configuration only works in RGB-PC mode.

Transmission [ j ][u][ ][Set ID][ ][Data][Cr]

Data 01: To set

Acknowledgement [u][ ][Set ID][ ][OK/NG][Data][x]

25. Channel Add/Del (Command: m b)

To add and delete the channels.
Transmission [m][b][ ][Set ID][		][Data][Cr]
Data 00: Channel Delete	Data 01: Channel Add
Acknowledgement [b][ ][Set ID][		][OK/NG][Data][x]

26.Key (Command: m c)

To send IR remote key code.

Transmission [m][c][ ][Set ID][ ][Data][Cr]

Acknowledgement [c][ ][Set ID][ ][OK/NG][Data][x]

Code	Remote control	Code	Remote control
(Hexa)		(Hexa)
0F	TV	39	CC
0B	INPUT	40	D
08	POWER	41	E
0E	TIMER	07	F
10-19	Number Key 0-9	06	G
4C	- (Dash)	44	ENTER
CB	ADJUST	43	MENU
09	MUTE	52	SOUND
02	VOL +	4D	PICTURE
03	VOL -	5B	EXIT
00	CH +	0A	SAP
01	CH -	1A	BACK
1E	FAV

27. Channel Tuning (Command: m a)

To tune channel to following physical/major/minor number.

Transmission [m][a][ ][Set ID][ ][Data00][ ][Data01]

[ ][Data02][ ][Data03][ ][Data04][ ][Data05][Cr]

Digital channels have a Physical, Major, and Minor channel number. The Physical number is the actual digital channel number, the Major is the number that the channel should

be mapped to, and the Minor is the sub-channel. Since the ATSC tuner automatically maps the channel to the Major number, the Physical number is not required when sending a command.

Data 00: Physical Channel Number

NTSC air: 02~45, NTSC cable: 01, 0E~7D

ATSC air: 01~45, ATSC cable: 01~87

Data 01 & 02: Major Channel Number

Data 01: High byte Data 02: Low byte

Two bytes are available for the Major and Minor, nor- mally only the second byte is used.

Data 03 & 04: Minor Channel Number

Not needed for NTSC.

72