LG Electronics 32LC7DC, 37LC7D, 42PC5DC Use only with the cart, stand, tripod, bracket, Grounding

Page 5

Use only with the cart, stand, tripod, bracket,

9 or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

of the appliance, and have the cord replaced with an exact replacement part by an authorized servicer. Protect the power cord from physical or mechanical abuse, such as being twisted, kinked, pinched, closed in a door, or walked upon. Pay particular attention to plugs, wall outlets, and the point where the cord exits the appliance.

10

Never touch this apparatus or antenna during

 

a thunder or lighting storm.

 

 

11

Do not allow a impact shock or any objects to

 

fall into the product, and do not drop onto the

 

screen with something.

 

 

12

Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has exposed to rain or moisture, does not operate normally, or has been dropped.

14 Outdoor use marking :

WARNING - To reduce the risk of fire or elec- tric shock, do not expose this appliance to rain or moisture.

15

Wet Location Marking : Apparatus shall not be

 

exposed to dripping or splashing and no

objects filled with liquids, such as vases, shall be placed on or over apparatus.

13 CAUTION concerning the Power Cord :

Most appliances recommend they be placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner's manual to be certain.

Do not overload wall outlets. Overloaded wall outlets, loose or damaged wall outlets, extension cords, frayed power cords, or damaged or cracked wire insulation are dangerous. Any of these conditions could result in electric shock or fire. Periodically examine the cord of your appliance, and if its appearance indicates dam- age or deterioration, unplug it, discontinue use

16 GROUNDING

Ensure that you connect the earth ground wire to prevent possible electric shock. If grounding methods are not possible, have a qualified electrician install a separate circuit breaker.

Do not try to ground the unit by connecting it to telephone wires, lightening rods, or gas pipes.

Power

Supply

Short-circuit

Breaker

17 DISCONNECTING DEVICE FROM MAINS Mains plug is the disconnecting device. The plug must remain readily operable.

3

Image 5
Contents 37LC7D 50PC5D 42LC7D 32LC7D 42PC5DPage FCC Notice Do not use this apparatus near water Safety InstructionsImportant Safety Instructions Grounding Use only with the cart, stand, tripod, bracketExposed to dripping or splashing and no Contents External Control Through RS-232C Time SettingIntroduction Feature of this TVPreparation AccessoriesPlasma TV Model Front Panel InformationFront Panel Controls LCD TV Model Remote Control SensorHere shown may be somewhat different from your TV Back Panel InformationBack Connection Panel Component ServiceAV OUT VideoBack Cover for Wire Arrangement Connect the cables as necessary How to remove the Cable ManagementEnsure the eye-bolts or brackets are tightened securely Attaching the TV to a WallStand Installation Only 32/37 inches LCD TV models Plasma TV Model LCD TV Model Desktop Pedestal InstallationVesa Wall Mounting Antenna Analog or Digital Antenna or Cable ConnectionHD Receiver Setup External Equipment SetupHow to connect How to useTurn on the digital set-top box External Equipment SetupExternal Equipment Setup Component Input ports DVD SetupConnect the video outputs Y, PB, PR of the DVD to Refer to the DVD players manual for operating instructionsRemote control Select AV1 input source by using the Input button onConnect the S-VIDEO output of the DVD to Video input on the setWhen connecting with an antenna VCR SetupMono jack of the set = white, and Audio Right = redInsert a video tape into the VCR and press Play on Ex LCD TV Model Other A/V Source SetupCamcorder Audio RGB-PC mode only 640x350 HDMI1/DVI-DTV, HDMI2-DTV mode RGB-PC, HDMI1/DVI-PC mode59.94 800x600Initializing Reset to original factory values Screen Setup for PC mode OverviewPhase Digital Audio Output AV OUT SetupWatching TV / Channel Control Remote Control FunctionsWatching TV / Channel Control Inside the Sliding Cover Installing BatteriesControl Volume AdjustmentTurning on TV ON-SCREEN Menus Selection SetupWatching TV / Channel Control Lock OptionAuto Scan EZ Scan Channel SearchAdd/Delete Channel Manual Scan Channel Editing After EZ Scan on the Setup menuThere are two different ways in order to add or delete Small window at the top-left corner of the screenDTV Signal Strength Watching Input Source SelectionSelect the source T V, AV1, AV2, Component1 Press the G button and then use D or Button toInput Label SimpLink Preparations SimpLink Menu SimpLink FunctionsPicture Control You can also adjust Aspect Ratio in the Option menuSet by program Become imprinted on the screen and remain visibleHorizon 169Zoom PictureEZ Picture Preset Preset Picture SettingsPicture Control Color Tone PresetSelect EZ Picture Manual Picture AdjustmentEZ Picture User Mode Or G button to Color Tone User ModeSelect X D XD Picture Improvement TechnologyAdvanced Cinema 32 Pull Down Mode Advanced Black Darkness Level Select Video Reset Picture ResetInversion OrbiterLOW Power Picture Mode Plasma TV only Sound & Language Control Preset Sound Settings EZ SoundLanguage Control SoundBalance Make appropriate adjustmentsSelect Balance Press the G button and then use F or G button toSound & Language Control TV Speakers ON/OFF SetupStereo, or SAP appear in turn STEREO/SAP Broadcasts SetupThem with the SAP button Press Exit button to save and return to TV viewingAudio Language Select Language ON-SCREEN Menus Language SelectionAnalog Broadcasting System Captions Caption / TextCaption TextOr French Digital Broadcasting System CaptionsSelect Caption/Text Customize the DTV/CADTV captions that appear on your screen Caption OptionSound & Language Size Set the word sizeAuto Clock Setup Time SettingClock Setting Time Setting Manual Clock SetupButton and then use Or E button to Auto ON/OFF Timer SettingSleep Timer Setting Select Auto Off Auto SHUT-OFF SettingTo select the Time menu Setting up Your Password SET Password & Lock SystemParental Control / Ratings Chip rating and categoriesRating Set PasswordLock System Parental Control / Rating Channel BlockingExternal Input Blocking Movie Rating Mpaa for USA only Movie & TV RatingTV Rating General for USA only TV Rating Children for USA onlyTV Rating English for Canada only Remote control Doesn’t work Power is suddenly Turned off TroubleshootingAppendix AppendixVertical bar or stripe on Background AppendixCleaning the Screen MaintenanceCleaning the Cabinet Extended AbsenceModels Product Specifications37LC7D 42LC7D Programming a code into a remote mode Programming the Remote ControlVCR Remote Control CodeHdstb Cable BoxDVD AudioIR Codes Remote Control IR CodesCode Function Type of Connector D-Sub 9-Pin Male RS-232C SetupExternal Control Through RS-232C GNDCommunication Parameters RS-232C ConfigurationsTransmission / Receiving Protocol Command Reference ListSet ID OK/NGDatax Set ID DataCr Step
Related manuals
Manual 4 pages 7.53 Kb