LG Electronics 263DCH, 323DCH owner manual FCC Notice

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions in the litera- ture accompanying the appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

 

CAUTION

 

 

 

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Image 3
Contents 26LG3DCH 32LG3DC 32LG3DCH LCD TVPage FCC Notice Important Safety Instructions Safety InstructionsGrounding Exposed to dripping or splashing and noChannel Setup Manual Picture AdjustmentSecuring the TV to the wall to prevent falling Clock Setting Auto Volume Leveler Auto VolumeFeature of this TV CD Manual AccessoriesPreperation PreparationMenu Button CHANNEL+, Buttons Volume +, ButtonsFront Panel Information 32LG3DC modelImage shown may differ from your TV Back Panel InformationHDMI/DVI Update / ResetRemote Control OUT Speaker OUT 8Ω VideoStand Body Cover Base DamageCables inside Cable ManagementShown PutDesktop Pedestal Installation Swivel StandDo not mount near or above type of heat source Protection Cover Vesa Wall MountingSame Securing the TV to the Wall to Prevent FallingAntenna Analog or Digital Antenna or Cable ConnectionHow to use External Equipment SetupHD Receiver Setup How to connect59.94 Hdmi ConnectionConnect the digital set-top box to HDMI/DVI Jack on the TV HDMI-DTVSetup DVI to Hdmi ConnectionExternal Equipment Connect the audio outputs of the DVD to DVD SetupComponent in Video jacks on the TV EquipmentVideo Connection Connect the S-VIDEO output of the DVD toVideo input on the TV Antenna Connection VCR SetupConnect the S-VIDEO output of the VCR to Composite RCA ConnectionOther A/V Source Setup Pin No Purpose VGA D-Sub 15 pin Connection PC Setup47.712 31.469 70.08 720x40070.08 640x480 31.469 59.94 800x600 37.879 48.363 60.00 1280x768 47.776Select the desired resolution Screen Setup for PC modeSelecting Resolution Select ResolutionMenu Select Picture Auto ConfigureAdjustment for screen Position, Size, and Phase ENTERSelect Screen RGB-PC Enter Select Reset Screen Reset Reset to original factory valuesRemote Control Functions only 32LG3DC model Watching TV / Channel ControlTV / Channel Control Installing Batteries UP/DOWNWatching TV / Channel Control Turning on TV Watching TV / Channel ControlChannel Selection Volume AdjustmentAudio ON-SCREEN Menus SelectionControl Channel SetupAuto Scan Auto Tuning Watching TV / ChannelAdd/Delete Channel Manual Tuning ENTERSelect Manual TuningReturn to the previous menu Return to TV viewing Channel Editing Channel Label Select the desired input source Input ListPicture Control Picture Size Aspect Ratio ControlPicture Control 169 Picture Mode Preset Preset Picture SettingsAdvanced Control Color Tone PresetPicture Mode User Mode Manual Picture AdjustmentPicture Picture Mode Expert ControlNoise Reduction, or Gamma Picture Improvement TechnologySelect Low or High Return Return to the previous menu Advanced Control Black Darkness LevelAdvanced Control EYE Care Advanced Control Real Cinema Initialize the adjusted value Picture ResetAuto Volume Leveler Auto Volume Sound & Language ControlSound & Language Control Clear Voice Sound &LANGUAGE ControlPreset Sound Settings Sound Mode Game your own settingsYou can also adjust Sound Mode in the Audio menu Sound & Language Sound Setting Adjustment User ModeSRS Trusurround XT Balance Turn the TV speakers off if using external audio equipment TV Speakers ON/OFF SetupMenu Select Audio ENTERSelect Reset Audio ResetMono, Stereo, or SAP appear in turn STEREO/SAP Broadcast SetupMenu Select Option ENTERSelect Language Audio LanguageMenus can be shown on the screen in the selected language ON-SCREEN Menus Language SelectionText Caption ModeAnalog Broadcasting System Captions CaptionMenu Select Option Enter Select Caption Digital Broadcasting System CaptionsMenu Select Option Caption OptionTime Setting Time SettingClock Setting Auto Clock SetupManual Clock Setup Time SettingAuto ON/OFF Time Setting Sleep Time turns the TV off at the preset time Sleep Timer SettingAuto SHUT-OFF Setting Chip rating and categories SET Password & Lock SystemSetting up Your Password Parental Control / RatingsParental Control / Rating Is enable Return Return to the previous menuLock System Select Lock SystemSame 4 digits on the Confirm Set PasswordChange the password by inputting a new password twice Input the password Select Set passwordBlock Channel Channel BlockingOr Blocking Off Movie & TV RatingMovie Rating Mpaa Select Movie RatingTV Rating Children Select TV Rating-Children Age applies to TV-Y, TV-Y7Select Age or Fantasy Violence TV Rating General Downloadable Rating External Input Blocking Enables you to block an inputAppendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixVertical bar or stripe on Background Picture OK & No sound No output from one SpeakersCleaning the Cabinet MaintenanceProduct Specifications Cleaning the ScreenRepeat frame Remote Control IR CodesIR Codes 1st frameCode Function