HDSTB Setup
-This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below.
-This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
How to connect
Use the TV’s COMPONENT (Y, PB, PR) INPUT, RGB or HDMI1/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections.
How to use
AUDIO IN(RGB/DVI) SPEAKER OUT(8 
)
1.Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)
2.Use INPUT on the remote control to select Component , RGB-DTV, or HDMI1/DVI source.
AC INPUT
Signal | Component | RGB1/2-DTV , HDMI1/DVI |
480i | Yes | No |
480p | Yes | Yes |
720p | Yes | Yes |
1080i | Yes | Yes |
| | |
RGB-DTV OUTPUT (R) AUDIO (L)
Digital Set-top Box
When supporting HDMI
1SERVICE ONLY
OPTICAL
| | | | | | | | |
| | | | (R) AUDIO (L) |
| | | |
DVI-DTV OUTPUT HDMI-DTV OUTPUT |
| | | | | | | | |
1.Connect the DVI output of the digital set-top box to the HDMI1/DVI IN or HDMI IN 2 jack on the set.
2.Connect the audio output of the digital set-top box to the AUDIO IN(RGB/DVI) jack on the set.
AUDIO IN(RGB/DVI) SPEAKER OUT(8 
)
3. Turn on the digital set-top box. (Refer to the owner’s manual for the digital set-top box.)
4.Select HDMI1/DVI or HDMI2 input source with using the INPUT button on the remote control.
• If the digital set-top box has a DVI output and no HDMI output, a separated audio connection is nec- essary.
•If the digital set-top box supports Auto DVI function, the output resolution of the digital set-top box will be automatically set to 1280x720p.
•If the digital set-top box does not support Auto DVI, you need to set the output resolution appropriately. To get the best picture quality, adjust the output res- olution of the digital set-top box to 1280x720p.
