Connecting a HIGH-DEFINITION HD Source | Audiovox FPE1908 manual

CONNECTIONS

CONNECTING A HIGH-DEFINITION (HD) SOURCE

High-Definition (HD) Devices with component video output must be connected to the YUV input. Connect the component video cable and audio cable (not included) as shown.

Make sure you connect the component video cable and audio cable from the other equipment (COMPONENT VIDEO OUT and AUDIO OUT) to this unit (COMPONENT VIDEO IN and AUDIO IN - YUV IN).

*May require a subscription for receiving HD channels. Check with your cable/ satellite service provider for details.

	HD SOURCE
	With component video output
To AUDIO	(Digital Cable Box*, Satellite
To AUDIO	Receiver*, or external
IN jacks	over-the-air HD-Tuner).
(YUV IN)	To AUDIO
	OUT jacks
COMPONENT	COMPONENT
VIDEO IN	VIDEO OUT
To COMPONENT	To COMPONENT
VIDEO IN jacks	VIDEO OUT jacks
(YUV IN)

NOTE

When connecting a DVD player to the television, the picture resolution is solely dependent upon the resolution supported by the DVD player attached. DVD player resolutions vary from 480i to 1080i, and this unit can support DVD players up to a maximum resolution of 1080i.

CONNECTING A PC

Connect the 15-pin D-SUB PC/VGA connector from your computer to the 15-pin D-SUB PC/VGA input on this unit using a monitor cable and an audio cable (not included) as shown.

Make sure you connect the cable from the computer (PC Connector and AUDIO - PC OUT) to this unit (MONITOR / VGA and AUDIO - PC IN).

To AUDIO jack (PC OUT)

To PC connector

E - 10

English.indd 10

6/11/2008 12:36:38 PM

CONNECTIONS