Audiovox FPE1507 manual Using Headphones, Unit Operation, Turning the Unit on for the First Time

Page 15

USING HEADPHONES

Turn down the volume before connecting headphones to the unit, then adjust the volume to your desired level.

When headphones are connected, no sound will come from the front speakers.

Note:

Avoid listening to sound at high levels for prolonged periods of time. This may be harmful to you and may cause hearing loss.

Earphones / Headphones

(1/8” [3.5mm] diameter plug)

UNIT OPERATION

TURNING THE UNIT ON FOR THE FIRST TIME

The first time for you turning on the unit, the unit will enter Virgin mode. You can easily follow up prompt message on screen to finish basic settings of the system.

1.

Press the ENTER button to proceed the Initial Setup.

2.

Use the / button to select your OSD language, and press the button to the next step.

3.Use the / button to select your TV tuner source (Antenna or Cable), and press the button to the next step.

4.Make sure RF aerial has been connected properly to TV ANTENNA input jack on the rear of

the system, press the ENTER or button. The system will automatically start to scan and preset all available TV channels.

5.After scaning finished, “Inital setup is Complete.” will appear on the screen. Press the ENTER button to finish Initial Setup.

After finishing above settings, the system will return to the first TV channel scaned just now.

Note: When the unit is not going to be used for a long time, disconnect the AC power cord from AC power outlet.

15

PLV1615CS1- E1-23.pmd

15

20/04/2007, 15:36

Image 15
Contents Flat Panel LCD TV Condensation Information Safety PrecautionsPlacement Information Safety InformationImportant Safety Instructions Table of Contents To Change the Remote Control Battery Remote ControlAccessories Using the Remote ControlRemote Control Reference Guide 7 8 10 11 12 1314 15 Unit Reference GuideConnections Connecting a TV ANTENNA/CABLE/SATELLITEConnecting a Digital Antenna Connecting an Analog Antenna or DeviceConnecting to Devices with an S-Video Output Connect to a VCRConnect to a camcorder Connections Connect to a VCR/PVR Connecting a PC Connecting a HIGH-DEFINITION HD SourceConnecting AN Audio Amplifier Connect the Power CordTo AC outlet Installation Removing the Base StandMounting on the Wall Using Headphones Unit OperationTurning the Unit on for the First Time PC Mode TV SetupTV Mode AV / YUV / DVD ModeVGA Settings in PC Mode AV / YUV / DVD / PC ModeAudio Menu Enter or Setup MenuChannel Skip Setting Skip, MTS or Audio Language. Adjust themTime Time Setup SettingTV Mode AV / YUV / DVD Mode DateCaption Setting Restore SettingParental Menu Parental Control Setting Symptom Cause and Remedy Trouble Shooting GuideUnit Inch