Audiovox FPE1907 Safety Precautions, Placement Information, Safety Information, FCC Information

Page 2

SAFETY PRECAUTIONS

 

CAUTION

 

RISK OF ELECTRIC SHOCK

 

DO NOT OPEN

AVIS

RISQUE DE CHOC ÉLECTRIQUE NE

PAS OUVRIR

* SEE REAR OF UNIT FOR GRAPHIC SYMBOLS *

The lightning flash with an arrowhead within a triangle alerts you to uninsulated dangerous voltage within the product's enclosure that could cause an electric shock.

The exclamation point within a triangle alerts you to the presence of important operating, maintenance and servicing instructions in this user’s manual.

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. DO NOT PLACE OBJECTS FILLED WITH LIQUIDS ON OR NEAR THIS UNIT.

CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE.

The symbol for Class II (Double lnsulation)

PLACEMENT INFORMATION

• Do not use this unit in places which are extremely hot, cold, dusty, or humid.

Do not restrict the air flow of this unit by placing it somewhere with poor air flow, by covering it with a cloth, or by placing it on bedding or carpeting.

SAFETY INFORMATION

When connecting or disconnecting the AC cord, grip the plug and not the cord itself. Pulling the cord may damage it and create a hazard.

When you are not going to use the unit for a long period of time, disconnect the AC cord.

CONDENSATION INFORMATION

When left in a heated room where it is warm and damp, water droplets or condensation may form inside the unit. When there is condensation inside the unit, the unit may not function normally. Let the unit stand for 1-2 hours before turning the power on, or gradually heat the room and let the unit dry before use.

FCC INFORMATION

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could avoid the user authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into

an outlet

on

a circuit different from

that

to

which

the

receiver

 

is connected.

 

 

 

 

 

 

 

 

 

Consult the dealer or

an experienced radio/TV technician for help.

 

 

 

 

Shielded cables must be

used

with this

unit

to ensure compliance

with

the

Class

FCC

limits.

WARNING: Should any problems occur, disconnect the AC cord and refer servicing to a qualified technician.

2

PLV36190CS1_IB_ENG_AUD.pmd

2

20/04/2007, 16:21

Image 2
Contents HD Flat Panel LCD TV Safety Information Safety PrecautionsPlacement Information Condensation InformationImportant Safety Instructions Table of Contents Using the Remote Control Remote ControlAccessories To Change the Remote Control BatteryRemote Control Reference Guide Color LCD Screen Standby Indicator Unit Reference GuideConnecting an Analog Antenna or Device Connecting a TV ANTENNA/CABLE/SATELLITEConnecting a Digital Antenna ConnectionsConnect to a camcorder Connecting to Devices with an S-Video OutputConnect to a VCR Connections Connect to a VCR/PVR Connecting a HIGH-DEFINITION HD Source Connecting a PCConnecting AN Audio Amplifier Connect the Power CordMounting on the Wall InstallationRemoving the Base Stand Turning the Unit on for the First Time Using HeadphonesUnit Operation PC Mode TV SetupAV / YUV / DVD Mode Video MenuTV Mode AV / YUV / DVD / PC Mode VGA Settings in PC ModeAuto Adjust, H. Position, V. Position, Phase or Audio MenuChannel Skip, MTS or Audio Language. Adjust Setup MenuChannel Skip Setting Enter orTime Update Time Setup SettingTV Mode AV / YUV / DVD Mode DatePassword Caption SettingRestore Setting TV ModeParental Control Setting Trouble Shooting Guide Symptom Cause and RemedyUnit Inch 15 1/2 12 3/4 12 1/2