Peerless Industries PP740 manual Installing and Removing Flat Panel Screen, Screen Clip Pocket

Installing and Removing Flat Panel Screen

To attach screen to wall mount (A), lower hook

3 bracket (M) with screen at an angle into pockets of wall mount as shown in figure 3.1. Once clips are engaged, push down to seat clips in pockets as shown in figure 3.2. Insert and tighten M5 phillips screw (K) to lock screen to wall mount as shown in figure 3.3.

To remove screen from mount, loosen screw (K) and lift screen off of mount.

WARNING

•Do not lift more weight than you can handle. Use ad- ditional man power or mechanical lifting equipment to safely handle placement of the screen.

•Failure to lock hook bracket (M) with screw (K) can cause screen to come off mount if hit accidentally.

CAUTION

•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 20 in. • lb (2.26 N.M.) maximum torque.

Adjust tension knob on side of mount shown in

4fig. 4.1 to desired tension to balance your screen size and weight.

Push or pull from top or bottom of screen to adjust tilt as shown. The tilt can be adjusted to a maximum of 15° forward or 5° backward.

K

SCREEN M

CLIP

POCKET

A

fig. 3.3

fig. 3.1 fig. 3.2

CAUTION

•Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.

CAUTION

•Be careful not to pinch fingers when opening and closing mount from the wall.

4-1Roll screen to desired position (5° clockwise or counter-clockwise). Insert #10-32 x 6 mm flat head phillips screw (O) to lock screen into position as shown in figure 4.2.

TENSION KNOB

O

fig. 4.2

fig. 4.1

9 of 20 ISSUED: 02-05-09 SHEET #: 202-9312-1