Peerless Industries DS-VW760 manual Tools Needed for Assembly Accessories, Table of Contents

Page 2

NOTE: Read entire instruction sheet before you start installation and assembly.

WARNING

Do not begin to install your Peerless product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, for US customers please call Peerless customer care at 1-800-865-2112, for all international customers, please contact your local distributor.

This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions.

Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.

Never exceed the Maximum Load Capacity. See page one.

If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended.

Always use an assistant or mechanical lifting equipment to safely lift and position equipment.

Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power.

This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.

This product was designed to be installed on the following wall construction only;

WALL CONSTRUCTION

HARDWARE REQUIRED

Wood Stud

Included

Wood Beam

Included

Solid Concrete

Included

Cinder Block

Contact Qualified Professional

Metal Stud

Contact Qualified Professional

Brick

Contact Qualified Professional

Other or unsure?

Contact Qualified Professional

Tools Needed for Assembly

Accessories

stud finder ("edge to edge" stud finder is recommended)

DS-ACC760 Cable Release Kit

phillips screwdriver

DS-VWS0## Wall Plate Spacer Kit

drill

 

• 5/16" (8 mm) bit for concrete and cinder block wall

 

• 5/32" (4 mm) bit for wood stud wall

 

level

 

Table of Contents

Horizontal and Vertical Video Wall Mount Assembly Formula

3

Parts List

4

Mounting and Removing Flat Panel Screen

8

Parts List

3

Installation to Wood Stud Wall

4

Installation to Solid Concrete or Cinder Block

5

Installing Tilt Brackets

6

Mounting and Removing Flat Panel Screen

 

 

 

2 of 14

ISSUED: 04-23-10 SHEET #: 145-9010-2 04-27-10

Image 2
Contents Installation and Assembly Full Service Video Wall Mount Model DS-VW760Tools Needed for Assembly Accessories Table of ContentsHorizontal Spacing Location Vertical Spacing LocationVertical Location Horizontal LocationParts List Removing Display Carriage Installation to Wall Stud Installation to Solid Concrete or Cinder Block Re-Attaching Display Carriage Attaching Adapter Brackets to DisplayAttaching Adapter Brackets to Display Carriage DetailDisplay Carriage Adjustment Down Rotate Left Rotate RightAdapter Bracket Adjustment Cable Management Open and Close Display Carriage Close Display CarriageOptional