Nextar MP907 user manual Turning On the Power, Playback Functions, Loading discs

Turning On the Power

			1.	Connect the power plug 1		to a power outlet.
			2.	Connect the DC output plug		2 of the adapter to
				the DC input jack on the main unit.
			3.	Hold down the	button on the main unit for
				about 2 seconds.
1		2	• The power indicator turns on. The player can now
				be used.
	Power adapter
			• In the standby mode (when the power indicator is lit
				red), the power can also be turned on by pressing
				the power button 3	on the remote control unit.

3

Hint:

The included AC adapter is compatible with voltages of 100 to 240V, so you can use it on trips overseas.

Note that you need a converter plug (available in stores) suited for the region in which you are travelling.

Playback Functions

Loading discs

1		1. Press button	A	to open the player case.
		2. Press button	B	to release the disc cover
	A	lock, the disc cover C will eject up.
2		3. Set the disc in place and press down on the
		disc with your fingers near the center hole. A
		click is heard.
		NOTE:
		• Set the disc securely. Failure to set it
B	C	securely could result in damage.
		• Do not use cracked or warped discs. Doing
		so could result in damage.
	A	• Set single-sided DVDs or CDs with he label
		(printed) side facing upwards. For
		double-sided DVDs, check the side carefully,
		then load the disc securely (until a click is
3		heard)
		• With CDs or one-sided DVDs, you do not
		have to worry about touching the label
		(printed) side of the disc with your fingers.
		Two-sided DVDs, however, have signals
		recorded on both sides, so be careful not to
		scratch them when removing them from the
		player.
		4. Press down disc cover C until a click is heard.
		Or further close the player case lock A , a click
		is also heard.

25 26