Features

Multi-Channel Remote Control

Battery Installation

•Operational range of up to 100 feet.

•Controls all Heath®/Zenith RF Tech Communica- tions™ products.

•FCC/IC tested and approved.

•Flash control on compatible receivers when using the Panic feature.

The Multi-Channel Remote Control is designed for 3 Volt operation:

1.Remove battery cover on rear of housing by pushing clip and lifting up.

2.Install 2-AAA bat- teries (not included) according to polarity markings.For best per- formance use alkaline batteries.

Battery Cover

Two AAA Batteries

(Not Included)

Installing 2-AAA Batteries

ENGLISH

Product Identification

Control Group and Indicators - Select
Group A or B lighting controls.
	A	B
ALL ON - Turns all lights within a Group ON.
Select either Group A or B then press ALL ON.	ALL ON	ALL OFF
	ON	DIM OFF

Light Control - ON

Light Control - DIM*

Light Control Selectors

PANIC* - All lights within a Group will PANIC flash ON and OFF. Select either Group A

or B then press PANIC.

ALL OFF - Turns all lights within a

Group OFF. Select either Group A or

B then press ALL OFF.

Light Control - OFF

Control Identification - Remove clear plastic film by placing two fingers on the plastic and “pinching” the plastic. Remove card. Write on the card to label each control. Replace card and plastic film.

*DIM Control: Dims lighting controls that are equipped with the dimming feature. Pressing DIM will toggle through the different dim levels. Each time the DIM button is pressed, the control LED will momentarily light.

The receiver saves the last dim setting used. To recall the last dim setting, press the DIM control once. Note: Not all lighting controls have the DIM and PANIC (flash) feature.

598-1145-01