Q-See QSDF8204 user manual Hold Time, Detection, Sensitivity, To REC, Schedule, Area

QSDF8204 Digital Video Recorder User Manual

1. HOLD TIME

This sets the continued recording time after an alarm is triggered. There are two options: 1 minute and 2 minutes. It also determines the interval between motion detection events. If the HOLD TIME is 1 minute, if new motion is detected within this period it will be considered part of the previous event instead of the start of a new event.

2. CHANNEL

STEP1 Move the cursor to the channel.

STEP2 Press "Enter" key to switch the channel and select.

3. DETECTION

Checking "DETECTION" means to enable motion detection, not checking means motion detection will not be enabled.

4. SENSITIVITY

This is the sensitivity level of the motion sensors.

The range is from ‘1’ to ‘8’. The higher the value, the more sensitive.

5. TO REC

If selecting "TO REC", DVR will record when motion is detected. If not, DVR will not record when motion is detected.

6. ALARM OUT

There are two options: ALARMOUT1 and BUZZER.

•When ALARMOUT1 is selected and an alarm is triggered, the DVR will give send signal to the alarm out port.

•When BUZZER is selected and the sensor is triggered, DVR will give a buzzer alarm.

When the alarm output is unselected, DVR will not send an alarm.

7. SCHEDULE

This is the schedule for the motion detection. The default schedule is everyday. Press "SETUP” button to set the motion detection schedule.

8. AREA

STEP1 Move the cursor to “setup”.

STEP2 Press "SETUP" button to enter the Area Setup submenu.

It displays the selected detection area (refer to Fig. 3.11). There are four options:

−ALL: motion anywhere in the area will be detected as shown in the picture.

−CUSTOM: You can select part of the area to be detected.

−NULL: No area will not be open to motion detection

−BACK: Go back to Motion Alarm Configuration menu.

18