Premier Mounts PWM-F110 installation manual Mounting Surfaces Figure

PWM-F110

3.To connect the two wall plates, lay them on a flat surface, end to end. Make sure that the holes line up (Figure 11).

4.Insert two (2) M8 x 16mm Hex Head bolts through the two holes and secure with two (2) M8 Hex nuts (Figure 11).

5.Place the bottom portion of the wall plate to the reference line and mark the eight (8) lag bolt mounting points through the wall plate slots on the wall.

6.Level the wall plate with the reference arrow pointing up to the ceiling (Figure 11).

Mounting Surfaces (Figure 14)

Wood studs: Drill eight (8) ¼" pilot holes to the marked wall (16”studs, on center – Figure 12).

Concrete wall: Drill eight (8) 3/8” pilot holes to the marked wall (Figure 18).

Drill Gun

Pilot

Holes

16"

Wall Plate

Mounting

Slots

Level

Wood Studs

Figure 11 Figure 12

NOTE: Although not depicted in the illustrations shown above, the width of this wall mount will encompass four wall studs (three wall studs if 24” apart).

Page - 11 - Installation Manual