Installing the PSM-Series mount

WARNING : Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display.

Step 1

CAUTION: The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product. Invert the plasma display and set it on a soft, flat surface to prevent any damage to the plasma display. See fig 1.

EXAMPLE PLASMA FOR ILLUSTRATION PURPOSES ONLY

Top of the plasma

displayInverted plasma display

Soft and flat surface	Bottom of the
blankets, foam, cloth	plasma display
etc.

Step 2

CAUTION: The plasma displays are fragile and heavy. At least two (2) qualified personnel are strongly recommended for the installation of this product. Locate the mounting points found on the back of the plasma chassis, align the mounting holes from the mounting bracket to the holes on the chassis. Arrow found on the PSM mount must always be pointing to the top of the plasma display before securing it to the chassis. Secure the mounting bracket to the plasma display by using the hardware specified on the parts list. CAUTION: Do not over tighten the mounting hardware. See fig 2.

WARNING: Do not use the drill gun to secure the screws to the plasma display. A Phillips head screwdriver is preferred.

PSM-series

mount

EXAMPLE PLASMA FOR ILLUSTRATION PURPOSES ONLY

Mounting hardware (see chart on pg 5)

NOTE: The PSM-402 was designed to work with more than one Hitachi model chassis. On some chassis only six (6) mounting points are going to match and eight (8) on others.

Inverted plasma

display