Firstech, LLC 2WAMR manual More Button Functions, Remote-Pager Learn Routine, Auto-Start Function

More Button Functions

(1) Time Setting

	Button	PressedFor	Function
STEP 1	(II+III) -	2 sec	Tones will sound for confirmation
STEP 2	(I)	1/2 sec	Time setting is on. The numbers will
			flash, and tones will sound.
STEP 3	(I)	1/2 sec	Change hour.
	(II)	1/2 sec	Change minutes.
STEP 4	(II+III) -	2 sec	Time setting is off. Tones will
			sound.

(2) RPS & Vibration mode on or off

	Button	PressedFor	Function
STEP 1	(II+III)-	2 sec	Tones will sound for confirmation
	(III)	1/2 sec	RPS on or off, tones will sound for
STEP 2			confirmation.
	(IV)	1/2 sec	Vibration mode on or off, tones will
			sound for confirmation.

Note : Step 2 must be completed within 15 seconds. If not, start over at step 1.

Remote-Pager Learn Routine

The Compustar system will allow up to three remotes to be programmed to one vehicle. Please perform the following procedure to add or reprogram additional remotes.

Step1 : Activate Valet/Programming mode by manually turning the ignition on and off five times (between Acc and On)

with the key within a 7 second period.

The parking light will flash once with successful completion of this step.

Step2 : Within a 7 second period after cycling the ignition for the 5th time, press button I. The parking lights will flash once to confirm that

the transmitter has been programmed. You can continue

programming additional remotes. The parking lights will flash two times when the programming mode has expired.

Auto-Start Function

Press button II for 2 seconds to auto-start an automatic transmission engine. Remember, that a key in the ignition is required to drive the car.

For manual transmission vehicles, please use reservation mode.

Press button II for 2 seconds in order to turn off an auto-started car.

The engine will run 15 or 25 minutes (25 or 45 min for diesel) depending on preset options at the time of installation and then shut off.

-	shows the amount of run-time left in the remote
	start mode.

Anti-Grind

The anti-grind circuit (an optional feature provided by your installer) prevents you from engaging the starter on a remote-started vehicle.

Page 8 Page 9