GETTING STARTED
Package contents
Before beginning, ensure that the carton contains the following items:
1. LCD Monitor
2. Monitor Base and Neck
(the shape of base may vary according to the monitor model)
3.Power Cord (plug may vary according to the electrical standards for your area)
4.Analog Signal Cable
5.Audio Cable (optional)
6.
7.Quick Installation Guide
Monitor installation
1.Setting up the monitor
1.1 Take out the monitor, stand and monitor base from the package.
1.2 Place the monitor base on the desk and then slide the neck into the slots of base. (Make sure the direction of the neck is correct.)
1.3 Grasp the monitor with both hands and then slide the monitor into the neck. (Make sure the direction of the neck is correct)
2.Connecting signal cable 2.1 Switch off your computer.
2.2 Connect the signal cable to the
2.3 Connect the other end of signal cable to the computer's VGA port port and tighten the connector screws.
2.4 Note: Ensure the display setting does not exceed 1280X720@75Hz.
3.Connecting audio cable (with audio option)
3.1Plug the audio cable into the AUDIO port at the rear of the monitor.
3.2Plug the other end of the audio cable into the audio
POWER | AUDIO |
port of your computer or other audio source. 4.Connecting power
4.1 Plug the female end of the power cord into the POWER port at the rear of the monitor.
4.2Plug the male end of the power cord into a power outlet. 5.Switching on
5.1 Switch on your computer.
You should now be able to see the picture. If not , refer to the trouble shooting section of this guide.
- 2 -