Elo TouchSystems SW601960 user manual Regulatory Information, Electrical Safety Information

Page 19

Chapter 7: Regulatory Information

I. Electrical Safety Information:

Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.

There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this equipment which constitute a safety hazard. Service should be provided only by a qualified service technician.

Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment to mains power.

II. Emissions and Immunity Information

Notice to Users in the United States: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

Notice to Users in Canada: This equipment complies with the Class A limits for radio noise emissions from digital apparatus as established by the Radio Interference Regulations of Industrial Canada.

Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for emissions or immunity as required by the following standards:

This Information Technology Equipment (ITE) is required to have a CE Mark on the Manufacturer’s label which means that the equipment has been tested to the following Directives and Standards: This equipment has been tested to the requirements for the CE Mark

User Manual: 43L Series

SW601960 Rev B, Page 19 of 24

Image 19
Contents Elo Touch Solutions 3243L Touchmonitors 4243L Touchmonitors Copyright 2014 Elo Touch Solutions, Inc. All Rights Reserved Table of Contents Introduction PrecautionsProduct Description Unpacking the Touchmonitor InstallationConnector Panel & Interfaces Touchmonitor Connections Side Bracket Mount Mounting General Mounting InformationFor 4243L monitors Rear Vesa Mount IntelliTouch Plus Touchscreen Technology PowerOperation TouchGesture Support On-Screen Display OSD VideoContrast Parameter Available Adjustment BrightnessPhase Auto AdjustOSD and Power Lockouts Problem Suggested Troubleshooting Solutions to Common ProblemsTechnical Support Technical Assistance Safety Safety & MaintenanceCare and Handling Waste Electrical & Electronic Equipment Directive Weee Regulatory Information Electrical Safety InformationII. Emissions and Immunity Information SW601960 Rev B, Page 20 IV. China RoHS III. Agency CertificationsSW601960 Rev B, Page 22 Warranty Information Check out our website Getting in Touch with Us