8. Installation
This chapter describes how to search for channels and a series of procedures.
8.1 Automatic Search
If your receiver is connected to the aerial and television, you can automatically search channels without entering any other information.
1.Select MENU 
button.
2.Select Installation using the 
button, and press the
OK 
or 
button.
3.Select Automatic Search from Installation menu using
the 
button, and press the OK 
or 
button.
4.Receiver starts to search channels automatically.
Search
Wait while the receiver searches for the channels, this may take a few minutes.
1.During operating search, the cursor is located at Stop
Therefore, if you press the OK 
button during searching, the operation is stopped and the channels found until then will be displayed.
2.If search operation is successfully completed, and the
channel does not exist, press the OK 
button and try to reset the search operation again if necessary.
3.You can delete unnecessary channels from the searched channels. Select your desired channels to delete and
press the OK 
button. Then select Delete and press
the OK 
button. To delete all channels, select Select All to select all channels, select Delete, and press the
OK 
button.
4.When completing Channel Search and deleting unnecessary channels, select Save to save the changes.
GB 44
**