DirecTV GAEB0, GCEB0 manual Test the VCR Record/Stop

8.Remove the temporary mounting tape. Attach the emitter permanently with peel-and-stick backing. This will not interfere with normal VCR operation. The VCR SETUP menu provides the settings to allow the DIRECTV Receiver to communicate with your VCR.

VCR SETUP			Thu, Jul 19 2:33 PM
Install
Signal
VCR	Brand	Code	Test
Prefs	Admiral	1	Record
Test	Aiwal	2	Stop
New Card
	Akai	3	Clear
Upgrade
	Audio Dynamics	4
Features
Watch TV	Bell & Howell	5
Main Menu	Brooksonic	6
	Canon	7

VCR SETUP menu pane

9.Scroll through the VCR brands using the Sjoystick and buttons.

If you cannot find the correct code listed for your brand of VCR brand, try related brands that use the same code. Also, your VCR may respond to multiple codes.

10.Use the remote control SELECT button to try each code.

11.Alternate between this procedure and testing the code.

Test the VCR (Record/Stop)

This Record/Stop test verifies the specified brand and code controls your VCR. Before starting the test:

•Turn the VCR power on.

•Verify the VCR Control Cable is properly connected.

•Insert a recordable videotape into the VCR.

Signals coming from the remote control at the same time as signals coming from the VCR Control cable may provide unreliable test results.

Use the DIRECTV Receiver front panel controls, rather than the remote control, to test the codes.

Test the VCR record and stop commands, If either command does not function, try other codes shown for your VCR brand. If you are unsuccessful after trying all available codes, recheck your VCR Control Cable connections and IR emitter placement.

Adding system components 11