1
3
5
DISH® Receiver Setup for SK-1000
The following instructions assume that the TRAV’LER® antenna has found and locked onto satellites 110°, 119° and 129°. There should be an asterisk next to 110°, 119°, and 129° on the TRAV’LER interface.
The following instructions are based on a ViP® 211 receiver. If your receiver differs from the options shown, you may need to consult your receiver manual. The wording and display used in your receiver may differ slightly.
For Help, Call 1-800-788-4417
Press Menu on | 2 | Select option 1, | |
your remote. | Installation. | ||
|
Select option 6,
System Setup.
Select option 1, | 4 | Select | |
Point Dish. | Check Switch. | ||
|
If your receiver is showing a switch type of DPP1K.2, then a check switch test is not necessary. In that case, skip to step 7 to complete DISH receiver setup.
If it is of any other type other than DPP1K.2, then check that there are no checkmarks by SuperDISH or Alternate, and select Test.
6
Verify that the | 7 | |
check switch | ||
| ||
resulted in a |
| |
switch type of DPP |
| |
1K.2 and that there |
| |
is a green OK |
| |
status on Satellite |
| |
110, 119 & 129. |
|
Press Cancel four times to exit the receiver menu.
The receiver setup is now complete.
Winegard and TRAV’LER are registered trademarks of Winegard Company.
DISH and ViP are registered trademarks of DISH Network L.L.C.