Dish Network manual Dish Receiver Setup for MP1 Antenna, For Help, Call

DISH® Receiver Setup for MP1™ Antenna

DISH receivers will often not show when they are on signal if they have incorrect “Check Switch” information. For this reason, DISH users must clear current settings before pointing. To do this for most DISH receivers, follow these steps. The following instructions are based on a ViP® 211 receiver.

If your receiver differs from the options shown, you may need to consult your receiver manual. The wording and display used in your receiver may differ slightly.

1

3

5

7

For Help, Call 1-800-788-4417

Before starting,	2
disconnect coax
from “Sat in” on
back of receiver.
Press Menu on
your remote.
Select option 6,
System Setup.

Select option 1,	4
Point Dish.

Check that there

are no checkmarks 6 by SuperDISH or Alternate. Select

Test.

This should clear out any previously installed devices. Then, select Done.

Re-connect the coaxial cable to the “Satellite In” port on the back of the receiver.

Select option 1, Installation.

Select

Check Switch.

The receiver will go through a number of steps and then may warn that fewer satellites were detected.

If so, select Save. It may ask you to confirm. If so, select Save again.