Dish Network VIP 722 manual Remote Control, Switching Between Dual and Single Mode

Satellite Receiver

Remote Control

Switching Between Dual and Single Mode

Put the satellite receiver in Single or Dual Mode by pressing the front panel MODE button. Keep the following items in mind when switching the satellite receiver between Dual and Single Mode:

		Dual Mode	Single Mode
Indications	Dual Mode front panel		Single Mode front panel
	indicator lights.		indicator lights.
Recording	The Recording front panel		The TV1 Recording front
	indicator lights to show		panel indicator lights when
	whether TV1, TV2, or both		you are recording from one
	are currently recording.		or both tuners.
Favorites	Favorites Lists set up for		Only Favorites Lists set up
Lists	both outputs (TV1 and TV2)		for TV1 are available. The
	are available.		lists for TV2 are not lost,
			they are simply unavailable
			in Single Mode.
Locks	Locks set up for both outputs		Locks set up for only TV1
	(TV1 and TV2) are available.		are available. The locks for
			TV2 are not lost, they are
			simply unavailable in Single
			Mode.
Closed	Closed Captioning (CC)		Closed Captioning from the
Captioning	from SD and HD		receiver is available on
	programming is available on		both outputs (TV1 and
	TV1. CC from only SD		TV2).
	programming is available on
	TV2 (CC must be enabled
	on the TV).

Note: If someone is viewing the remote TVs while the receiver is in Dual Mode, you will see a popup on the nearby TV warning you that you are about to disrupt the use of the TV2 outputs.

Remote Control

The two remote controls give you access to all the features of your satellite receiver. You can set up each remote to control the satellite receiver and up to three other devices (see page 75). These devices can be a TV, a VCR or DVD player, and a third device.

This section describes how to use the various features on the two types of remote controls included with your satellite TV system.

15