Kathrein UFD 540 manual Here, you will also find instructions for downloading

Page 69

Software and Channel list Update

turns to operation. If an error or incorrect signal occurs, a message appears "Download error."

Never switch the receiver off during the update procedure, or the en- tire software will be lost. If this should occur, the receiver must be newly installed at the factory or per PC and zero modem cable. Dur- ing the download, the following message flashes:

„Please wait"

Observe the on-screen displays!

After a software update, you must set the time again!

The updates are also available in the internet under the address: www.esc-kathrein.de/download/ufd/.

Here, you will also find instructions for downloading.

69

Image 69

Contents Operating manual DVB Caravan Receiver UFDPage Preface Contents Oscillator frequency L.O Changing the oscillator frequency Technical Annex Data Transfer from Receiver to ReceiverSafety Instructions View of front panel View of rear panel Control Elements, Displays and Connections... Remote control handset buttonsCommand of Remote Control Operating Instructions Menu conceptButton functions Alphanumeric entries Button Language selection- OSDPreconditions for receiving signals Connecting receiverPresetting of receiving system Connection and Start-upLNB supply voltage Inserting batteries in the remote controlTV and video recorder connection Audio connectionFirst Time Installation Factory setting of receiverFirst steps On Screen Displays / OSD Important screen displaysHelp function Error message TV channel identifierRadio channel identifier Channel List Radio/TV Videotext Programme Selection Selecting a TV programmeReception status Programme Selection Selecting a TV programme by number entry Switch-over to a radio programmeReception status radio Screen turns dark after a few secondsSelecting a radio programme by number entry Common Interface Observe the operating manual of your Pay-TV providerYou are responsible for inserting the cards Common Interface Common Interface Timer Settings VPS signal Sound Settings Volume settingStereo and two-channel sound reproduction AC3 Switching off soundChannel list Selecting programmes last receivedFavourite programmes Channel list Channel list Channel list Channel list Search programmes alphabetically Sorting programmes Deleting programmes  Be careful when delet- ing programmesManually adding programmes Channel list Adding and Removing Satellites Setting up satellitesRemoving satellites Entering satellite namesEPG Programme OverviewEPG timer programming Programme Overview Password Factory settingEntering a password Password Parental lock Password Operation from Front Panel Backup operationSetting System Parameters System information System parametersTV type Local time/TimerPicture format ScreenLNB configuration Installation menuChanging the oscillator frequency DiSEqC setting Antenna rotor / Positioner DiSEqC Antenna settingsSatellite search TP set-up/search Transponder selection All new programmes are added to the existing channel list DiSEqC UFO Set-up KHz signalTone burst After the reset, it may be necessary to repeat all settings Pre-programming is not deleted with ResetAutomatic Antenna Alignment with HDP Software and Channel list Update „Display info, a display appears, which you should follow Here, you will also find instructions for downloading Preparation Data Transfer from Receiver to ReceiverTransferring channel lists Transferring operating softwareTechnical Annex Technical featuresTechnical data Accessories Switch-over VHS/S-VHSScart socket assignments Digital sound Hi-fi or Dolby digital system Connection exampleShort Technical Lexicon Transponder Video bit rateViterbirate DVB GlossaryService SatelliteDiSEqC menu Page 9362588/A/0505/ZWT Subject to technical changes