Shure WA405 manual Connecting Receivers, Antenna Distribution, Power Distribution

CONNECTING RECEIVERS

Antenna Distribution

Using low-loss, 50 Ω coaxial cables (RG 58 or equiva- lent), connect the right and left (Channels 1 through 4, A and

B)RF OUTPUT ports on the WA405 to the corresponding left and right (A and B) antenna inputs on each receiver.

Power Distribution

1.Using the supplied ac power cable, connect the WA405 to an ac power outlet.

If the supplied power cable does not match your mains outlet, use an IEC 320 type mating connector and the ap-

propriate mains plug. The supplied cord uses Harmonized IEC Cordage with color coding as follows:

Brown = Line

Blue = Neutral

Green/Yellow = Ground

2.Using the supplied dc power cables, connect each re- ceiver to ONE of the four dc power outputs on the WA405.

NOTE: Do not overload the WA405 by attempting to power more than four receivers.

ANT	OUTPUTS		POWER	ANT
	BAL
B				A
	MIC	LINE	12.5 ± 18.9 VDC

OUTPUTS		POWER	ANT
ANT
BAL
B			A
MIC	LINE	12.5 ± 18.9 VDC

ANT	OUTPUTS	POWER
	BAL
B
	MIC LINE	12.5 ± 18.9 VDC

ANT

A

ANT	OUTPUTS		POWER	ANT
	BAL
B				A
	MIC	LINE	12.5 ± 18.9 VDC

WA405 SETUP

FIGURE 8

3