Shure UAPF-X1 manual Installation Instructions

INSTALLATION

IMPORTANT: DO NOT USE INFORMATION:

This device must not be used with antennas or other devices that have a DC short circuit at their feed point without using an external (BNC) DC Block. A suitable BNC DC Block is the JFW Industries Model 50DB-002.

Installation Instructions

1.Thread the Shure Model UAPF-X1 unit on the supplied stand or on a 5/8 in.-27 thread microphone stand (Figure 2) and connect the antenna wand to either antenna port (filter functions in both directions).

To Antenna

Figure 2. Attaching Base and Antenna

2.Using 50 W low-loss coaxial cable (purchased separately, Shure UA825 or UA850 or UA8100 recommended), connect to the opposite port to the Shure Model UR4 or ULX, SLX wireless receiver or UA845SWB, or UA844SWB Antenna Distribution System (Figure 3).

Wall Mounted

To Receiver

Antenna In

UR4 Wireless Receiver

Mic stand mounted

Figure 3: Connecting Receiver

4