Telex UAD4 instruction sheet System Configuration, Front View, Rear View Front and Rear View

Page 2

System Configuration

Figure 2 illustrates the typical system configura- tion using the UAD4.

Figure 3 illustrates an arrangement where two splitters have been cascaded. By connecting one of the outputs of the first splitter to the antenna inputs of the second splitter, three additional re- ceivers may be driven by a single pair of anten- nas.

SPECIAL NOTE: In any system, unused split- ter outputs should be terminated with a 50 ohm “dummy load”. See the accessories listing at the end of this manual.

Telex UAD4

ANTENNA

POWERSPLITTER

Front View

 

 

 

 

 

 

 

 

 

 

 

90-260 VAC 50-60 Hz

INPUT A

 

 

OUTPUT A

 

POWER OUT

 

 

OUTPUT B

 

INPUT B

1

2

3

4

1

2

3

4

2

3

 

 

 

 

1

4

 

 

 

 

 

 

 

 

 

15 VDC

 

 

 

 

 

POWER

Rear View

Figure 1

Front and Rear View

-2-

Image 2
Contents Features General DescriptionRear View Front and Rear View System ConfigurationFront View System Configuration CascadingAntenna Placement Antenna RequirementsAntenna Connectors Antenna Placement for Optimum Range and Rack MountingRack Mounted Antenna Connectors Rack MountingVolt Power On Antenna In Jacks Moving Jumper Be sure to move jumper on both headersUAD4 Cables Model Type AC Power CablesTP-2 50 OHM/TNC dummy load UAA-500Telex COMMUNICATIONS, INC. All rights reserved July