Channel set-up
Naming or renaming channels
The Select PR line is selected.
Display the number of the channel whose name you want to change using the PR+/PR- buttons.
The relevant channel appears. Select the PR name option and press the | button to place the cursor on the first | |
character. |
|
|
Using the | buttons, select a character from the list, which includes letters from the alphabet, numbers between 0 and | |
9, the characters +,. and space. |
| |
Go on to the next character or back to the previous character using the | buttons and start the procedure again. | |
Press OK to confirm. Names can have a maximum of six characters. |
| |
EN
Press EXIT to close the menu.
Note:You may subsequently return to ORGANISER menu:
Display the OVERVIEW menu by pressing the MENU button.
Select the Installation option and press OK to confirm.
Select the Organiser option from the INSTALLATION menu and press OK to confirm.
To carry out the automatic
Manual channel set-up
Follow the procedure given on this page if you find that some channels have not been stored during the initial
MANUAL INSTALLATION |
|
Return |
|
Standard | UK... |
Frequency | 150.75 MHz |
Fine tuning |
|
PR | 05 |
Decoder |
|
Character set | 1... |
Display the OVERVIEW menu by pressing the MENU button. Select the Installation option and press OK to confirm. Select the Manual instal. option from the INSTALLATION menu and press OK to confirm.
1.Select the Standard option and then the relevant standard for your country using the 
buttons.
Note: the following standards are available to choose from: UK for the UK and Ireland, FR for France and Luxembourg, DK for Eastern Europe, the Middle East and Asia, EURO for Western Europe, Australia and New Zealand.
2.Select the Frequency option. Use the 
or 
button to start the search in descending or ascending order.When a channel is found pictures appear.
3.If the picture is not clear you can adjust the setting.You do this by selecting the option Fine tuning and adjusting it
with the 
buttons.
4.If the channel is encrypted and you want to connect a decoder, select the Decoder option and check the box by pressing the OK button.
5.Then select the Character set option and choose the character set that will be used for Teletext on this channel using
the 
buttons.The following character sets are available:
1 :Western Europe
2 : Eastern Europe
3 : Russian and Bulgarian
4 : Greek
5 :Arabic
6 : Ukrainian
7 : Belarussian
The character set selected determines how characters are displayed on Teletext screens.
6.Select the PR option to assign a number to the channel. Enter the number using the numeric buttons. Press the OK button to confirm.
Important: as soon as you change a setting in the MANUAL INSTALLATION menu the channel number starts flashing under the PR option. To confirm your change you must select the PR option and press OK. If you do not confirm the change it will be cancelled when you change channel or put the television into standby mode.
Repeat this procedure to find other channels.
7