Extron electronic MBU 123 manual For furniture mounting, For projector mounting, Headquarters

MBU 123 Under Desk Mounting Kit and

PMK 100 Mini Pole Mount Kit Installation Guide

Furniture mount or projector mount the quarter-rack width product using the optional mounting kit (part number 70-212-01, furniture; or 70-217-01, projector) as follows:

1.Attach the mounting brackets to the product with the machine screws provided (see the figure on the other side of this card).

2.If feet were previously installed on the bottom of the unit, remove them.

For furniture mounting —

3.Hold the unit with the attached brackets against the underside of the table or other furniture. Mark the location of the screw holes of the bracket on the mounting surface.

4.Drill 3/32-inch (2 mm) diameter pilot holes, 1/4 inch (6.3 mm) deep in the mounting surface at the marked screw locations.

5.Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until just less than 1/4 inch of the screw head protrudes.

6.Align the mounting screws with the slots in the brackets and place the unit against the surface, with the screws through the bracket slots.

7.Slide the unit slightly forward or back, then tighten all four screws to secure the unit in place.

Extron USA - West -	Extron USA - East	Extron Europe	Extron Asia	Extron Japan	Extron China	Extron Middle East
Headquarters	+800.633.9876	+800.3987.6673	+800.7339.8766		+400.883.1568
+800.633.9876	Inside USA/Canada Only	Inside Europe Only	Inside Asia Only		Inside China Only
Inside USA/Canada Only	+1.919.863.1794	+31.33.453.4040	+65.6383.4400	+81.3.3511.7655	+86.21.3760.1568	+971.4.2991800
+1.714.491.1500	+1.919.863.1797 FAX	+31.33.453.4050 FAX	+65.6383.4664 FAX	+81.3.3511.7656 FAX	+86.21.3760.1566 FAX	+971.4.2991880 FAX
+1.714.491.1517 FAX

© 2011 Extron Electronics. All rights reserved. www.extron.com

68-705-01

Rev. B

05 11

MBU 123 Under Desk Mounting Kit and

PMK 100 Mini Pole Mount Kit Installation Guide,

Continued

For projector mounting —

1.Using a locally-supplied nut and bolt, or other appropriate hardware, secure the product to a projector mount or other surface by inserting the mounting hardware through the slotted hole in the bracket.

Projector Mounting

Bracket

Mounting

Bolt

Under Desk Mounting Projector Mounting