Humminbird 530516-1_D warranty Thank You, Installation Overview, Determine Where to Mount

1

Quick Disconnect Mounting Bracket 530516-1_D

Thank You

Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.

Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment. In the unlikely event that your Humminbird® accessory does require repairs, we offer an exclusive Service Policy - free of charge during the first year after purchase, and available at a reasonable rate after the one-year period. For complete details, see the Warranty section included in this manual.

Contact our Customer Resource Center at 1-800-633-1468or visit our website at www.humminbird.com.

Installation Overview

Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read these instructions carefully in order to get the full benefit from your Humminbird® accessory.

If you find that any items are missing from your installatio n kit, call our Customer Resource Center at 1-800-633-1468or visit our website at www.humminbird.com.

To install your Quick Disconnect mounting system, you will need a drill, your control head, the mounting bracket, the connector holder, the power cable, the mounting hardware, a 9/64" drill bit, a 1" hole saw, a Phillips and a flat-head screw driver, an adjustable wrench, a level, and marine-grade silicone sealant.

Installation

Perform the procedures in the following sections to install the Wide Quick Disconnect mounting system on your boat.

1. Determine Where to Mount

Begin the installation by determining where to mount the control head. Consider the following to determine the best location:

•To check the location planned for the control head, test run the cables for power, transducer and Temp/Speed accessory (if applicable).

•There are two ways to route the cables to the unit: through a hole in the mounting surface underneath the mounting bracket, or from a hole outside the mounting bracket. Routing the cables under the mounting bracket provides maximum weather protection; this may not be feasible, however, if the area under the control head is inaccessible. In this case, route the cables through a hole at another location and cover with the supplied hole cover.

•The mounting surface should be stable enough to protect the control head from excessive wave shock and vibration, and should provide visibility while in operation.

•The mounting area should allow sufficient room for the unit to pivot and swivel freely, and for easy removal and installation (see illustrations).

360 Degree Swivel

90 Degree Tilt

© 2008 Humminbird®, Eufaula AL, USA. All rights reserved.