Chief Manufacturing PCM Series Adjustments, Display Roll Adjustment, Display Height Adjustment

Installation Instructions PCM SERIES

To use as a more permanent lock, remove pin and nuts and move to lower holes

1

2

Display Roll Adjustment

To adjust display roll:

1.Loosen 3/8-16 Nylock nut. (See Figure 7)

2.Adjust faceplate to desired position. (See Figure 7)

3.Tighten 3/8-16 Nylock nut. (See Figure 7)

1

A padlock or bolt may

be placed through latch holes

Figure 5

Adjustments

The PCM is designed to accommodate 5" of display height adjustment, 4º right and left display roll adjustment, and 15º down/5º up display pitch (Tilt) adjustment.

Remove display before performing adjustments.

Display Height Adjustment

To adjust display height:

1.Loosen four 5/16-18 button head cap screws using 3/16" hex wrench (C). (See Figure 6)

2.Adjust faceplate to desired position. (See Figure 6)

3.Tighten four 5/16-18 button head cap screws using 3/16" hex wrench (C). (See Figure 6)

1

3

2

Figure 6

2

3

Figure 7

Display Pitch (Tilt) Adjustment

To adjust display pitch:

1.Loosen four 5/16-18 button head cap screws. (See Figure 8)

2.Adjust to desired tilt position. (See Figure 8)

3.Tighten four 5/16-18 button head cap screws. (See Figure 8)

1

3

2

Figure 8

5