Niles Audio RCA-HT Connecting the 12VDC IN-LINE Power Supply and Microflashers, Connection Ports

Page 8

INSTALLATION (CONTINUED)

STEP 3 – CONNECTING THE 12VDC IN-LINE POWER SUPPLY AND MICROFLASHERS

Plug the MicroFlashers into any of the sockets labeled FLASHER OUTPUTS on the connection hub

(Figure 5). Plug the connector on the supplied 12VDC power supply into the socket labeled POWER on the connection hub and then plug the wall adapter into a live electrical outlet. The power LED should light. If the LED does not light, confirm that the outlet you used is live by plugging in a lamp.

Figure 5: Connection Ports

TECH TIP: Make all final connections to the MSU before connecting the power supply. This will avoid potential damage to components.

6

Image 8
Contents RCA-HT Table of Contents CongratulationsContents IntroductionInstallation Considerations Getting Started InstallationTools Required MSU250 Installation Placing the Connection HUBConnecting the Sensor Cable to Connection HUB Removable Connector PlugConnecting the 12VDC IN-LINE Power Supply and Microflashers Connection PortsInstallation Mounting a Microflasher to A/V Components Mounting the Connection HUB Make sure that your system tested OK before proceedingWall-mount placement Running the Sensor CableConnecting Power Supply an Flashers Normal Operation System OperationOptional Accessories Status Feedback Wall AdapterScheduling and Preparation Running Sensor Cable in NEW ConstructionAdditional Sensors Safety First DrillingConcealing Sensor Cable in Existing Walls Pulling the CableInstallation Unobstructed space Specifications MF1VFNiles Audio Corporation 1-800-BUY-HIFI Limited Warranty Warranty Registration Card Dr. Miss Mr. Mrs. MsL e s a u d i o C o r p o r a t i o n