IR Range, Audio Power Handling | Niles Audio LZR800 instruction

Individual ON/OFF but- tons for each pair

of speakers.

P R E L I M I N A R Y T E C H N I C A L D A T A S H E E T

RSL-6

Remote Controlled Speaker Selection System

SPECIFICATIONS

INTRODUCTION

IR Range

30 feet @ 30 degrees off-axis

Audio Power

Handling

250 watts/channel con- tinuous music power

Frequency Response

20 Hz to 20kHz +0dB, -0dB (flat)

The RSL-6 is a Infrared Remote
Controlled Speaker Selection
System for up to six pairs of
speakers. The supplied remote
control enables you to select		SPKR	2
any pair, any combination		SPKR
any pair, any combination		1
of pairs, or all six pairs of	SPKR	1
of pairs, or all six pairs of	SPKR	SPKR
speakers at once. You don’t have		SPKR

to worry about overloading your amplifier. The RSL-6 has a programmable microprocessor that constantly monitors which speakers are playing and selects exact- ly the right amount of protection for your amplifier.

SPKR	4

SPKR	5

ALL OFF button turns your entire

system off.

SPKR	6

OFF ALL

REMOTE

SELECTOR

SPEAKER

Hand-held IR remote gives you convenient control.

Mounting

Table-top component

Wiring Requirements

Individual runs of

2-conductor speaker wire. Connectors can accommodate 14-22 gauge

Overall Dimensions

17" Wide x 2" High x 8-3/4" Deep

Weight 6-1/2LBS

		ALL-ONbutton		enables you to
		turn on all or some of your speakers
		depending upon the rear panel DIP
		switch settings.
Red POWER LED turns green		Red LED indicators	Recessed areas for			ALL-ONbutton enables you to turn on
momentarily confirming that an		for each pair of	custom room		labels.	all or some of your speakers depending
IR command was detected.		speakers.				upon the rear panel DIP switch settings.
RSL- 6 REMOTE HIGH DEFINITION SPEAKER SELECTION SYSTEM
						ALL ON ALL OFF
	1	2	3	4	5	6
Infrared Sensor	Attractive low-	Simple push-button ON/OFF				ALL OFF button turns your
	profile design.	operation for each pair.				entire system off.

FEATURESAND BENEFITS

Remote Control

Computerized Protection Room LED’s and Labels. Proudly Made in USA

The slim, elegant remote con- trol (included) allows you to completely control which speakers are playing. Each pair of speakers has its own ON/OFF button. In addition, a program- mable A L L O N button (you select which rooms will turn on) and an A L L O F F button allow you to conveniently stop or start your music with one touch!

The brain of the RSL-6 is an eight bit modified Harvard Architec- ture Microcontroller. The micro- controller is programmed to remember the impedance of each of your speaker pairs and your amplifier’s ideal load. It constantly monitors how many speaker pairs are playing (and which pairs), calculates the exact amount of impedance protection necessary, and pro- vides the proper amount of pro- tection for your amplifier.

Red LED’s indicate when a pair of speakers is on. 72 pre-print- ed room labels are included for easy identification.

X-10®Powerline Control

Using optional X-10 wireless remotes and controllers you can control the RSL-6 through the existing 120v AC electrical wires in your home. Optional Niles TW-523 interface module is required.

The RSL-6 is made in Miami, Florida and comes with a limit- ed two year parts and labor warranty.

B L E N D I N G H I G H F I D E L I T Y

A N D A R C H I T E C T U R E ®

CONTINUED OTHER SIDE