Omnimount 1002379 Models G343, G343T, G348 Espagnol, Slide middle shelf onto bottom shelf. a

Step 7

Slide middle shelf onto bottom shelf. (Fig. 7a)

Grasp middle shelf firmly and lift it into position. (Fig. 7b) Align rear of middle shelf with rear support bracket. (Fig. 7c)

Rotate middle shelf into position into side support brackets. (Fig. 7d)

Caution: Ensure that rear and side brackets are fully engaged before releasing grasp on shelf.

Fig. 7a Fig. 7b Fig. 7c Fig. 7d

Step 8

Tighten rear shelf bracket screw. (Fig. 8a)

Re-secure the side brackets as close to shelf as possible. (Fig. 8b)

Place top shelf onto upper frame members. (Fig. 8c) Note: If the top shelf glass is unstable, move the rubber pad positions or double up the height of the lowest pad until the shelf glass is stable.

Models: G343, G343T, G348 — Espagnol

Caution: Never try to move table by pulling on glass shelves. Always move table by grasping the frame.

Fig. 8b Fig. 8c

Fig. 8a

Paso 1

Fig. 1b

Instale los pies nivelables encima de las almohadillas inferiores del poste trasero. (Fig. 1a)

Instale las cubiertas de los puertos de cables en el poste trasero.
(Fig. 1b)	Fig. 1a

Specifications are subject to change without prior notice.

Every effort has been made to provide accurate and error-free assembly and installation. OmniMount Systems disclaims liability for any difficulties arising from the interpretation of information contained in these instructions. If OmniMount products are used for purposes other than their original intent, OmniMount, its distributors and retailers shall not be held responsible or liable for injuries or property damage, direct, indirect, or consequential, which may arise from the inability to use this product safely, properly, and in the manner for which it has been designed and manufactured. War- ranty does not apply to products which have been lost, damaged by misuse, abuse, or accident.

4

Paso 2

Usando la llave hexagonal incluida, enrosque los tornillos de cabeza hexagonal, sin apre- tar mucho, para fijar los pies de soporte con el cuadro principal (Fig. 2a)

Fig. 2b		Fig. 2a
	Fije el poste trasero al soporte usando los tornillos largos de
	cabeza hexagonal y la llave hexagonal incluida. (Fig. 2b)
	Apriete bien todos los tornillos de los pies de soporte.
	Ponga la mesa de pie.

Paso 3

Determine la altura deseada del estante central.
Instale un tornillo Phillips y las pastillas de estantería en el soporte trasero del estante. (Fig.
3a)	Fig. 3a

17